Kenmore W10215709A Performance Data Sheet, Model TIKB1/TIRFKB1 Capacity 100 Gallons 379 Liters

PERFORMANCE DATA SHEET

Base Grille Water Filtration System

Model TIKB1/TIRFKB1 Capacity 100 Gallons (379 Liters)

Chlorine Taste and Odor, Particulate Class I ; and against NSF/ANSI Standard 53 for the reduction of

SystemLead, Mercury,tested andAtrazine,certifiedBenzene,by NSFToxaphene,Internat!onal O-Dichlorobenzene,against NSF/ANSI StandardCysts, Turbidity,42 for theAsbestos,reductionLindane,of

Tetrach oroethy ene, Endr n, A ach or, Ch orobenzene, Ethy benzene, TTHM, MTBE and VOC.

This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The

concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the

permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.

Substance		Reduction	NSF Reduction		Average			Influent		Challenge		Maximum				Average			Minimum	%	Average	%
Aesthetic	Effects		Requirements		Influent			Concentration				Effluent				Effluent			Reduction		Reduction
Chlorine Taste/Odor			50%	reduction	2.0 mg/L			2.0 mg/L		+ 10%		0.08		mg/L **		2.0	mg/L		95.93		97.36
Particulate	Class I*		85%	reduction	3533333#/mL			At east		10,000 part c es/mL		22000			#/mL	11567		#/mL	99.38		99.67
Contaminant			NSF Reduction		Average			Influent		Challenge		Maximum				Average			Minimum	%	Average	%
Reduction			Requirements		Influent			Concentration				Effluent				Effluent			Reduction		Reduction
Lead: @ pH 6.5			0.010	mg/L	150 ug/L			0.15	mg/L+		10%	1.0	ug/L			1 ug/L			99.33		99.33
Lead: @ pH		8.5	0.010	mg/L	157 ug/L			0.15 mg/L_+ 10%				2.0	ug/L			1.08 ug/L			98.72		99.31
Mercury:	@ pH 6.5		0.002	mg/L	0.0058		mg/L	0.006	mg/L		+ 10%	0.0002			mg/L	0.0002		mg/L	96.53		96.53
Mercury:	@ pH 8.5		0.002	mg/L	0.0057		mg/L	0.006	mg/L		_+10%	0.0002			mg/L	0.0002		mg/L	96.5		96.5
Benzene			0.005	mg/L	15 ug/L			0.015	mg/L_+ 10%			0.5	ug/L			0.5	ug/L		96.67		96.67
O-Dichlorobenzene			0.6 mg/L		1750 ug/L			1.8 _+10%				1.0	ug/L			1.0 ug/L			99.94		99.94
Toxaphene			0.003	mg/L	15 ug/L			0.015	_+10%			1.0	ug/L			1.0	ug/L		93.33		93.33
Atrazine			0.003	mg/L	10 ug/L			0.009	mg/L		_+10%	2 ug/L				2 ug/L			80.8		80.8
Asbestos			99%		101 MFL			107to	108fibers/L _			0.17		MFL		0.17	MFL		99.83		99.83
Live Cysts _			>99.95%		120,000/L			50,000/L		min.		8/U		NTU		1/ U	NTU		99.99		>99.99
Turbidity			0.5 NTU		11.4 NTU			11 _+1 NTU				0.41				0.24			96.4		97.89
Alachlor			0.002	mg/L	41.3	ug/L		0.04	_+10%			0.2	ug/L			0.2	ug/L		99.52		99.52
Endrin			0.002	mg/L	5.9	ug/L		0.006	+	10%		0.5	ug/L			0.3	ug/L		91.5		95.47
Ethylbenzene			0.7 mg/L		1867 ug/L			2.1 _+10%				0.70		ug/L		0.0588		ug/L	99.96		100
Lindane			0.002	mg/L	1.9 ug/L			0.002	_+10%			0.02		ug/L		0.02	ug/L		98.93		98.93
Chlorobenzene			0.6 mg/L		2.0 ug/L			2.0 _+10%				0.0005			ug/L	0.0005		ug/L	99.98		99.98
Tetrachloroethylene			0.005	mg/L	14.2 ug/L			0.015	_+10%			0.5	ug/L			0.5	ug/L		96.47		96.47
TTHM			0.080	mg/L	465	ug/L		0.45	_+20%			1.0	ug/L			0.5	ug/L		99.78		99.88
MTBE			0.005	mg/L	14 ug/L			0.015	_+20%			0.70		ug/L		0.52	ug/L		94.94		96.27
VOC			0.015	mg/L	0.3520		mg/L	0.300	_+10%			0.0060			mg/L	0.0008		mg/L	98.4		99.78

Test Parameters: pH = 7.5 _+0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 100 gallons (379 liters).

•

It is essential

that

operational,

maintenance,

and

filter

•

Do not

use with

water that

is microbiologically

unsafe

or

of

replacement

requirements

be carried out

for

the

product to

unknown

quality

without

adequate

disinfection

before

or

after the

perform as advertised.

system.

Systems

certified

for cyst

reduction

may be

used on

•

Model

TIKBI"

The filter

monitor system

measures

the

amount of

disinfected waters that may contain filterable cysts.

water

that

passes

through

the filter and alerts you to replace the

•

Refer to

the

"Warranty"

section

for

the

Manufacturer's

name,

filter.

address

and

telephone

number.

Style

1 - When the filter

indicator

reads

10%,

order a

new filter.

•

Refer to

the

"Warranty"

section

for

the

Manufacturer's

limited

When

the

indicator

reads

0%,

it is

recommended

that

you

warranty.

replace

the filter.

Style 2 - When the filter indicator changes from green to yellow, order a new filter. When the indicator changes from yellow to red, it is recommended that you replace the filter.

Style 3 - When the water filter status display changes from "GOOD" to "ORDER," order a new filter. When the filter indicator reads "REPLACE," it is recommended that you replace the filter. Use replacement cartridge T1 RFKB1, part #9030.

2008 suggested retail price of $59.99 U.S.A./S71.99 Canada. Prices are subject to change without notice.

•These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary.

•The product is for cold water use only.

*Class I particle size: >0.5 to <1 um

**Test requirement is at least 100,000 particles/mL of AC Fine Test Dust. ttFibers greater than 10 um in length

€Based on the use of Cryptosporidium parvum oocysts

	Application	Guidelines/Water	Supply	Parameters
Water	Supply
Water	Pressure	30 - 120 psi (207 - 827 kPa)
Water	Temperature	33 ° - 100°F		(0.6 ° - 37.8°C)
Service	Flow Rate	0.5 gpm (1.9		L/min) @ 60 psi

® NSF is a registered trademark of NSF International.

25