ENGLISH
Explanation of general view
1 | Button | 11 | Thumb screw | 21 | Low speed |
2 | Battery cartridge | 12 | Sleeve | 22 | High speed |
3 | Terminal cover | 13 | Bit | 23 | Speed change lever |
4 | Charging light | 14 | Bit holder | 24 | Action mode changing ring |
5 | Grip base | 15 | Switch trigger | 25 | Arrow |
6 | Teeth | 16 | Reversing switch lever | 26 | Adjusting ring |
7 | Side grip | 17 | A side | 27 | Graduations |
8 | Loosen | 18 | B side | 28 | Limit mark |
9 | Tighten | 19 | Clockwise | 29 | Brush holder cap |
10 | Depth rod | 20 | Counterclockwise | 30 | Screwdriver |
SPECIFICATIONS
Model | BHP460 |
Capacities |
|
Concrete | 16 mm |
Steel | 13 mm |
Wood | 38 mm |
Wood screw | 10 mm x 90 mm |
Machine screw | 6 mm |
No load speed |
|
High | 0 – 1,500 |
Low | 0 – 460 |
Blows per minute |
|
High | 0 – 22,500 |
Low | 0 – 6,900 |
Overall length | 267 mm |
Net weight (with battery cartridge) | 2.7 kg |
Rated voltage | D.C. 24 V |
•Due to our continuing program of research and devel- opment, the specifications herein are subject to change without notice.
•Note: Specifications may differ from country to country.
Safety hints
For your own safety, please refer to the enclosed safety instructions.
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER & BATTERY CARTRIDGE
1.SAVE THESE INSTRUCTIONS — This manual contains important safety and operating instruc- tions for battery charger.
2.Before using battery charger, read all instruc- tions and cautionary markings on (1) battery charger, (2) battery, and (3) product using bat- tery.
3.CAUTION — To reduce risk of injury, charge only MAKITA type rechargeable batteries. Other types of batteries may burst causing personal injury and damage.
4.Do not expose charger to rain or snow.
5.Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to per- sons.
6.To reduce risk of damage to electric plug and cord, pull by plug rather than cord when discon- necting charger.
7.Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
8.Do not operate charger with damaged cord or plug — replace them immediately.
9.Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.
10.Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
11.To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.
12.The battery charger is not intended for use by young children or infirm persons without super- vision.
13.Young children should be supervised to ensure that they do not play with the battery charger.
ADDITIONAL SAFETY RULES
FOR CHARGER & BATTERY CARTRIDGE
1.Do not charge battery cartridge when tempera- ture is BELOW 10°C (50°F) or ABOVE 40°C (104°F).
2.Do not attempt to use a
3.Do not allow anything to cover or clog the charger vents.
4.Do not short the battery cartridge:
(1)Do not touch the terminals with any conduc- tive material.
(2)Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc.
(3)Do not expose battery cartridge to water or rain.
A battery short can cause a large current flow, overheating, possible burns and even a break- down.
5.Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F).
6.Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire.
4