Makita G1200R instruction manual Periodic Maintenance, Easy maintenance

Page 16

6.PERIODIC MAINTENANCE

Proper maintenance of the generator will allow reliable performance and reasonable maintenance cost. This section outlines a standard schedule for this purpose. This schedule should be adjusted as necessary to conform to the owner's conditions of use.

Fuel level -E

Condition of engine

Air cleaner

Bolts and nuts

oil and level

-element

for looseness

 

Leakage of

Connection of

Surrounding

Noise or

gasoline or oil

-appliance

--area

-vibration level

Easy maintenance

 

 

Every 50 hours

Wash cleaner element (or everyday when operating in extremely

Every 100 hours

dusty conditions.), clean spark plug.

 

Change oil.

 

 

Every 6 months

Adjust spark plug gap.

 

(200 hours)

 

 

 

See page 15 for detailed information.

Draw up the most convenient schedule for conducting required checks, on the basis of the maintenance schedule outlined on the next page.

PERIODIC MAINTENANCE (UNDER NORMAL OPERATING CONDITIONS)

Every 6 months

Clean fuel filter.

(200 hours)

Replace spark plug and cleaner element, clean / adjust carburetor,

Every 12 months

(500 hours)

cyl. head, valve clearance, valve seat and engine switch.

Every 24 months

Inspect control panel parts, rotor and stator.

(1,000 hours)

Replace engine mount,overhaul.

1.Change fuel lines if any leakage is found or after every two years regardless of usage.

2.Overhauling includes checking dimensions and adjusting or replacing component parts according to Repair Standards in the Service Manual.

It is recommended that the generator be overh,auledevery 2 years(1,OOO hours).

For USA only : Clean spark arrester.

- 13 -

Image 16
Contents Model GI Z O O R Page Table of Contents ForewordFire prevention8 Safety PrecautionsPrevention of electrical shock Other safety instructions Exhaust gas precautionsNecessary inspections and checks Component Identification Fuel Controls and Indicators Fuel CockVoltmeter DC receptacleFrequency adjusting screw AC circuit breaker DC circuit breakerStarter handle Ground Earth TerminalChecking engine oil level Checking fuel levelChecking the area around the generator Operating Procedures StartingAC application DC application For charging 12V battery only Stopping generator Periodic Maintenance Easy maintenanceDo-it-yourself service Periodic maintenanceEasy Checking and Maintenance Air cleaner servicingCleaning procedure Engine oil changeCleaning fuel strainer Spark arrester cleaningChecking the spark plug Preparation for Storage When engine fails to start TroubleshootingWhen no electricity is generated at receptacle Heating Resistance Power factor 1.O, No starting current IO.APPLICABLE Wattage of the GeneratorTable below shows the values for a 1OOm wire Specifications US GalWiring Diagram Makita Corporation