AC application

-Check the voltmeter for proper voltage.

The generator is thoroughly adjusted and tested in the factory. If the generator does not produce the

specified voltage, consult your nearest Generator dealer.

-Check the electrical appliance to see if its switch is

turned off, then connect the appliance to the generator.

-Switch on the appliance.

eApplicable AC wattage :

The following table shows the maximum wattage of various appliances which can be connected to the generator. Before connecting an appliance, make sure its wattage is within the range.

Electrical appliance

Lamp, electrical heater, radio, stereo sets, etc.

Electric tools

Applicable limit 60Hz

up to 1ooow

up to about 600W

CAUTION]

1, When connecting plural appliances make sure the total wattage does not exceed the generator's rated output. Otherwise the generator will not operate due to excessive wattage.

2.Some power tools require a large starting current. In these cases, it may not be possible to use the generator. Refer to page 20, or consult your dealer to obtain the necessary information.

3.When overloaded, the AC circuit breaker pops out to cut off the current. In such a case, make sure that the applied wattage of the appliance has not exceeded the wattage limit and that there are no defects in the appliance. Then push the circuit breaker back into the "ON" position.

- 10 -