Makita G1200R Safety Precautions, Fire prevention8, Prevention of electrical shock

Page 4

1. SAFETY PRECAUTIONS

Fire prevention8

0 When refueling : - Stop the engine.

- Extreme care must be taken to prevent fire hazards. Avoid smoking and the use of matches or open flame.

- Be sure to fill fuel tank up to the specified level. Do not overfill.

- Spilled fuel must be wiped off thoroughly. Afterv- spilled fuel has dried, start the engine.

( '

0Location of generator :

-The generator should be placed at least 1 meter (3 ft) away from buildings or other facilities.

-The surrounding area should be free of inflammables (trash, chips of wood, etc.) and hazardous materials (lubricants, celluloid items, explosives, etc.).

0

0While in use :

-Be sure to operate the generator on a level surface. Avoid tilting or moving while in operation.

-The generator should not be covered or enclosed by a box.

Prevention of electrical shock

-Never use the generator in the rain or snow.

-Never operate the generator with wet hands.

-Never spray water to clean the generator.

- 1 -

Image 4
Contents Model GI Z O O R Page Table of Contents ForewordFire prevention8 Safety PrecautionsPrevention of electrical shock Other safety instructions Exhaust gas precautionsNecessary inspections and checks Component Identification Fuel Controls and Indicators Fuel CockVoltmeter DC receptacleFrequency adjusting screw AC circuit breaker DC circuit breakerStarter handle Ground Earth TerminalChecking engine oil level Checking fuel levelChecking the area around the generator Operating Procedures StartingAC application DC application For charging 12V battery only Stopping generator Periodic Maintenance Easy maintenanceDo-it-yourself service Periodic maintenanceEasy Checking and Maintenance Air cleaner servicingCleaning procedure Engine oil changeCleaning fuel strainer Spark arrester cleaningChecking the spark plug Preparation for Storage When engine fails to start TroubleshootingWhen no electricity is generated at receptacle Heating Resistance Power factor 1.O, No starting current IO.APPLICABLE Wattage of the GeneratorTable below shows the values for a 1OOm wire Specifications US GalWiring Diagram Makita Corporation