Makita G1200R instruction manual Controls and Indicators, Fuel Cock, Voltmeter, DC receptacle

Page 8

3.CONTROLS AND INDICATORS

CHOKE2”:OPTo start the engine, turn the knob to

CLOSE

FUELOPEN v7

Fuel cock

\

CHOKE

 

this position.

 

 

(Choke valve is closed.)

 

 

Keep the knob in this position after

RUN

 

the engine starts. (The engine can be

 

started with the knob at this position

 

 

1 STOP

1

when the engine is warm.)

To stop the engine, return the knob to

this position.

Fuel Cock

0 Controls the supply of fuel. CLOSE : Engine stops. OPEN : Engine runs.

Voltmeter

0 Indicates the AC voltage output of generator

.AC receptaclesAC receptacle

0 AC electric power is available through this receptacle. Use

aground type, three-leg plug as shown.

I

\

I

0 0

7:” 8.3A

DC receptacle

DC receptacle

0 DC electric power for battery charge is available.

- 5 -

Image 8
Contents Model GI Z O O R Page Table of Contents ForewordPrevention of electrical shock Safety PrecautionsFire prevention8 Necessary inspections and checks Exhaust gas precautionsOther safety instructions Component Identification Fuel Controls and Indicators Fuel CockVoltmeter DC receptacleFrequency adjusting screw AC circuit breaker DC circuit breakerStarter handle Ground Earth TerminalChecking engine oil level Checking fuel levelChecking the area around the generator Operating Procedures StartingAC application DC application For charging 12V battery only Stopping generator Periodic Maintenance Easy maintenanceDo-it-yourself service Periodic maintenanceEasy Checking and Maintenance Air cleaner servicingCleaning procedure Engine oil changeChecking the spark plug Spark arrester cleaningCleaning fuel strainer Preparation for Storage When no electricity is generated at receptacle TroubleshootingWhen engine fails to start Heating Resistance Power factor 1.O, No starting current IO.APPLICABLE Wattage of the GeneratorTable below shows the values for a 1OOm wire Specifications US GalWiring Diagram Makita Corporation