Craftsman 917.276920 manual To Install Mower, To Level Mower, Visual SIDE-TO-SIDE Adjustment

Page 25

9.Turn tractor steering wheel to the left as far as it will go.

10.Slide mower out from under right side of tractor.

TO INSTALL MOWER

Follow procedure described in "INSTALL MOWER AND DRIVE BELT" in the As-

sembly section of this manual.

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over

or under inflated, it may affect the appear- ance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT

1.With all tires properly inflated and if your lawn appears unevenly cut, de-

termine which side of mower is cutting lower.

NOTE: As desired, you can raise the low side of mower or lower the high side.

2.Go to side of mower you wish to adjust.

3.With a 3/4" or adjustable wrench, turn lift link adjustment nut (A) to the left to lower the mower, or, to the right to raise the mower.

_, CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

2.Raise mower to its highest position.

3.At both sides of mower, position blade at side and measure the distance

(A) from bottom edge of blade to the

ground. The distance should be the same on both sides.

S

_'.....

4.If adjustment is necessary, see steps 2

and 3 in Visual Adjustment instructions above.

5.Recheck measurements, adjust if nec-

essary until both sides are equal.

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side- to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear

tip when the mower is in its highest posi- tion.

_IL CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to highest position.

•Position any blade so the tip is pointing straight forward. Measure distance (B)

to the ground at front and rear tip of the blade.

Turn nut right

Turn nut left

to raise mower

to lower mower

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

4.Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE

ADJUSTMENT

1.With all tires properly inflated, park tractor on level ground or driveway.

•If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.

•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

•With a 3/4" or adjustable wrench, turn front link adjustment nut (B) clockwise (Itighten) to raise the front of mower, or,

counterclockwise (loosen) to lower the front mower.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Crrftsmiin Days on Battery Limited Warranty on Craftsman Tractor and BatteryYear on Tractor General Operation I1. Slope Operation Service Safe Handling of GasolineII1. Children IV. TowingGeneral Service Customer Responsibilities ProductRepair Protection Agreements Mower Front Wheel Check Battery Tools Required for AssemblyAdjust Seat To Remove Tractor from Carton Unpack CartonAssemble Front Wheel to Mower Install Mower and Drive BeltAttach Mower Side Suspension 02937 Check Tire Pressure ChecklistCheck Deck Levelness Check for Proper Position of ALL BeltsAutomatic Models only Know Your Tractor Attachment Clutch SwitchMower Blades Ground Drive HOW to USE Your Tractor To SET Parking BrakeEngine To Adjust Gauge Wheels To Operate Mower Using the Reverse Operation SystemTo Operate on Hills To TransportBefore Starting the Engine Check Engine OIL Level Towing Carts and Other AtfachmentsADD Gasoline To Start EngineAutomatic Transmission Warm UP Purge TransmissionMowing Tips Schedule Each MaintenanceSeason Storaqe USE Hours Hours Hours HoursBattery Belts Transaxle Pump FluidEngine Lubrication To Change Engine OILMuffler Clean AIR INTAKE/COOLING AreasIN-LINE Fuel Filter To Remove Mower CleaningVisual SIDE-TO-SIDE Adjustment To Install MowerFRONT-TO-BACK Adjustment Precision SIDE-TO-SIDE AdjustmentMower Drive Belt Removal Mower Drive Belt InstallationBelt Installation To Adjust Attachment ClutchTo Replace Motion Drive Belt Belt RemovalTo Start Engine with a Weak BAT Tery Replacing Battery Fuel System EngineEngine OIL CylindersCorrection CauseStart Problem Cause Correction TroubleshootingchartLoss of power Poor cut unevenFast Not rotateNot Across Hill Only Ride UP and Down HillDegrees MAX DiAS Para LA BATERiA Anos Para EL TractorFUNClONAMIENTO General Operaciones DE Servicio Generales IV. RemolquePage API-SG-SL Especificaciones DEL ProductoResponsabilidades DEL Cliente Acuerdos DE Proteccion Para LA ReparacionTubo de desage Se a0oraVerifique LA Bateria Herramientas Necesarias Para EL MontajePara Hacer Rodar EL Tractor Remover EL Tractor DE LA PlataInstale Primero LA Barra ANTI-BAL- Anceo S Monte Rueda Delatentera DE LA SegadoraFijelaspiezasdepropulsionpos Revision DE LA Nivelaoion DEL Conjunto Revision DE LA Presion DE LAS LlantasRevision DE LA Posicion Adecua DA DE Todas LAS Correas @@@@ SU Tractor Familiaricese CON SU TractorInterruptor DE LA LUZ Enciende y apaga las luces delanteras Impulsion DE Recorrido Parada Cuchillas DE LA SegadoraMotor Para Usar EL Control DE LA AcelerMoverse Hacia Adelante Y Hacia Atras Para Usar EL Control DE Estrangulacion NUtilizar EL Mando Crucero Para Ajustar LA Altura DE Corte DE LA SegadoraPara Operar LA Segadora Usar EL Sistema DE FuncionamientoPara Parar LAS Cuchillas DE LA Sega Para Operar EN CerrosMecanismo DE Aviso DE SERVIClO Transmision DesenganchadaAntes DE Hacer Arrancar EL Motor Arranque CON Tiempo Templado 50 Y M,,S Para Hacer Arrancar EL MotorCalentamiento Para LA Transmision Automatica Consejos Para Segar Recomendaciones Generales Programade MantenimientoAntes DE Cada USO Cuidado DE LA Cuchilla TractorRemocion DE LA Cuchilla BaterjaNivel DEL Fluido DE LA Bomba DEL Transeje Enfriamiento DEL TransejeCorreas Motor LubricacionLimpieza DE LA Entrada DE AIRE/AREAS DE Enfriamento Limpieza DE LA Rejilla DE AireBUJiAS LimpiezaPara Instalar LA Segadora Para Desmontar LA CortadoraAjuste DE Delante a ATR,.S Para Nivelar LA SegadoraRegulacion DE LA Precision DE Lado Montaje DE LA Correa DE TRANSMIS- ION DE LA Segadora Desmontaje DE LA Correa DE TRANS- Mision DE LA SegadoraPara Cambiar LA Correa DE Impul Sion DE Movimiento Para Ajustar EL Embrague DEL ACCE- SorioDesmontaje DE LA Correa Montaje DE LA CorreaImpresion / Inclinacion DE LAS RUE DAS Delanteras Para Verificar SI Funciona Bien EL FrenoPara Remover LAS Ruedas Para Hacer Reparaciones Para Hacer Arrancar EL Motor CON UNA Baterja BajaPara Cambiar LA Bombilla DE LA LUZ Delantera Reemplazar LA BateriaMotor Aceite DEL Motor Motor Sistema DE CombustibleOtros Problema Identificacion DE ProblemasVibracion Excesiva El tractor se pon ProblemacausaProblema Causa Correccion Grados MAX Operacion SeguraSerifs

917.276920 specifications

The Craftsman 917.276920 is a versatile and reliable lawn tractor designed to tackle a range of outdoor tasks while delivering exceptional performance. This machine is equipped with advanced features and technologies that make lawn care easier and more efficient for homeowners.

One of the key characteristics of the Craftsman 917.276920 is its powerful engine. It typically comes with a robust 24 horsepower Kohler engine that provides ample power for cutting even the thickest grass. The engine is designed for reliability and durability, ensuring that users can depend on it for multiple seasons of heavy use.

The cutting deck is another standout feature of the Craftsman 917.276920. With a 54-inch cutting width, it allows for fast mowing over large areas. The deck height is adjustable, providing users with the flexibility to achieve the perfect lawn height, whether they prefer a short, manicured look or a longer, more natural appearance. The mower also features a dual-blade system that further enhances cutting performance, ensuring a clean and even finish.

In terms of user comfort, the Craftsman 917.276920 is designed with ergonomics in mind. It comes with an adjustable high-back seat that provides support during long mowing sessions. The steering system is also user-friendly, featuring a smooth and responsive maneuverability that makes navigating tight spaces and obstacles easy. Additionally, the tractor's controls are intuitively placed for straightforward operation, reducing the learning curve for new users.

Another important feature of this lawn tractor is its versatility. The Craftsman 917.276920 is compatible with various attachments, including baggers, mulchers, and even snow blowers, allowing it to handle multiple tasks throughout the year. This adaptability makes it a valuable tool for homeowners looking to maintain their yards across seasons.

For those concerned about maintenance, the Craftsman 917.276920 includes features designed for easy upkeep. The engine is equipped with an easy-access oil fill and filter, simplifying routine maintenance. The cutting deck can also be easily removed for cleaning and servicing, ensuring that the mower stays in peak condition.

Overall, the Craftsman 917.276920 lawn tractor combines power, comfort, and versatility, making it an excellent choice for homeowners seeking a reliable solution for their lawn care needs. Its advanced features and technologies contribute to a practical and enjoyable mowing experience, allowing users to achieve professional-looking results in their own backyard.
Top Page Image Contents