Craftsman 917.276920 manual Replacing Battery

Page 29

REPLACING BATTERY

,AWARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,

rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

1.Lift hood to raised position.

2.Disconnect BLACK battery cable (A) then RED battery cable and carefully remove battery from tractor.

3.Install new battery with terminals in same position as old battery.

4.First connect RED battery cable (B) to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover (C) over terminal.

5.Connect BLACK grounding cable to negative (-) battery terminal with re- maining hex bolt and keps nut. Tighten securely

6.Close hood.

Negative

(Black) Cable

Positive

(Bed) Cable

TO REPLACE

IGHT BULB

1.Raise hood.

2.Remove bulb holder from the hole in the backside of the grill.

3.Replace bulb in holder and install bulb holder securely back into the hole in

the backside of the grill.

4.Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause

your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type

plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL AS- SEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of tractor.

4.When replacing hood, be sure to re- connect the headlight wire connector.

Headlight Wire

Connector

ENGINE

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any non-road

engine repair establishment or individual. Warranty repairs must be performed by an

authorized engine manufacturer's service outlet.

CARBURETOR

If your engine does not operate properly due to suspected carburetor problems, take your tractor to a Sears or other qualified service center for repair and/or adjustment.

High speed stop is factory adjusted. Do not adjust - damage may result.

IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeed- ing the engine above the factory high

speed setting can be dangerous. If you

think the engine-governedhigh speed needs adjusting, contact a Sears or other qualified service center,, which has proper equipment and experience to make any necessary adjustments.

29

Image 29
Contents Crrftsmiin Year on Tractor Limited Warranty on Craftsman Tractor and BatteryDays on Battery General Operation I1. Slope Operation Service Safe Handling of GasolineII1. Children IV. TowingGeneral Service Repair Protection Agreements ProductCustomer Responsibilities Mower Front Wheel Check Battery Tools Required for AssemblyAdjust Seat To Remove Tractor from Carton Unpack CartonAttach Mower Side Suspension Install Mower and Drive BeltAssemble Front Wheel to Mower 02937 Check Tire Pressure ChecklistCheck Deck Levelness Check for Proper Position of ALL BeltsAutomatic Models only Know Your Tractor Attachment Clutch SwitchEngine HOW to USE Your Tractor To SET Parking BrakeMower Blades Ground Drive To Adjust Gauge Wheels To Operate Mower Using the Reverse Operation SystemTo Operate on Hills To TransportBefore Starting the Engine Check Engine OIL Level Towing Carts and Other AtfachmentsADD Gasoline To Start EngineAutomatic Transmission Warm UP Purge TransmissionMowing Tips Schedule Each MaintenanceSeason Storaqe USE Hours Hours Hours HoursBattery Belts Transaxle Pump FluidEngine Lubrication To Change Engine OILIN-LINE Fuel Filter Clean AIR INTAKE/COOLING AreasMuffler To Remove Mower CleaningVisual SIDE-TO-SIDE Adjustment To Install MowerFRONT-TO-BACK Adjustment Precision SIDE-TO-SIDE AdjustmentMower Drive Belt Removal Mower Drive Belt InstallationBelt Installation To Adjust Attachment ClutchTo Replace Motion Drive Belt Belt RemovalTo Start Engine with a Weak BAT Tery Replacing Battery Fuel System EngineEngine OIL CylindersStart CauseCorrection Problem Cause Correction TroubleshootingchartLoss of power Poor cut unevenFast Not rotateDegrees MAX Only Ride UP and Down HillNot Across Hill DiAS Para LA BATERiA Anos Para EL TractorFUNClONAMIENTO General Operaciones DE Servicio Generales IV. RemolquePage API-SG-SL Especificaciones DEL ProductoResponsabilidades DEL Cliente Acuerdos DE Proteccion Para LA ReparacionTubo de desage Se a0oraVerifique LA Bateria Herramientas Necesarias Para EL MontajePara Hacer Rodar EL Tractor Remover EL Tractor DE LA PlataInstale Primero LA Barra ANTI-BAL- Anceo S Monte Rueda Delatentera DE LA SegadoraFijelaspiezasdepropulsionpos Revision DE LA Posicion Adecua DA DE Todas LAS Correas Revision DE LA Presion DE LAS LlantasRevision DE LA Nivelaoion DEL Conjunto @@@@ Interruptor DE LA LUZ Enciende y apaga las luces delanteras Familiaricese CON SU TractorSU Tractor Impulsion DE Recorrido Parada Cuchillas DE LA SegadoraMotor Para Usar EL Control DE LA AcelerMoverse Hacia Adelante Y Hacia Atras Para Usar EL Control DE Estrangulacion NUtilizar EL Mando Crucero Para Ajustar LA Altura DE Corte DE LA SegadoraPara Operar LA Segadora Usar EL Sistema DE FuncionamientoPara Parar LAS Cuchillas DE LA Sega Para Operar EN CerrosAntes DE Hacer Arrancar EL Motor Transmision DesenganchadaMecanismo DE Aviso DE SERVIClO Calentamiento Para LA Transmision Automatica Para Hacer Arrancar EL MotorArranque CON Tiempo Templado 50 Y M,,S Consejos Para Segar Antes DE Cada USO Programade MantenimientoRecomendaciones Generales Cuidado DE LA Cuchilla TractorRemocion DE LA Cuchilla BaterjaNivel DEL Fluido DE LA Bomba DEL Transeje Enfriamiento DEL TransejeCorreas Motor LubricacionLimpieza DE LA Entrada DE AIRE/AREAS DE Enfriamento Limpieza DE LA Rejilla DE AireBUJiAS LimpiezaPara Instalar LA Segadora Para Desmontar LA CortadoraRegulacion DE LA Precision DE Lado Para Nivelar LA SegadoraAjuste DE Delante a ATR,.S Montaje DE LA Correa DE TRANSMIS- ION DE LA Segadora Desmontaje DE LA Correa DE TRANS- Mision DE LA SegadoraPara Cambiar LA Correa DE Impul Sion DE Movimiento Para Ajustar EL Embrague DEL ACCE- SorioDesmontaje DE LA Correa Montaje DE LA CorreaImpresion / Inclinacion DE LAS RUE DAS Delanteras Para Verificar SI Funciona Bien EL FrenoPara Remover LAS Ruedas Para Hacer Reparaciones Para Hacer Arrancar EL Motor CON UNA Baterja BajaMotor Reemplazar LA BateriaPara Cambiar LA Bombilla DE LA LUZ Delantera Otros Motor Sistema DE CombustibleAceite DEL Motor Problema Identificacion DE ProblemasVibracion Excesiva El tractor se pon ProblemacausaProblema Causa Correccion Grados MAX Operacion SeguraSerifs

917.276920 specifications

The Craftsman 917.276920 is a versatile and reliable lawn tractor designed to tackle a range of outdoor tasks while delivering exceptional performance. This machine is equipped with advanced features and technologies that make lawn care easier and more efficient for homeowners.

One of the key characteristics of the Craftsman 917.276920 is its powerful engine. It typically comes with a robust 24 horsepower Kohler engine that provides ample power for cutting even the thickest grass. The engine is designed for reliability and durability, ensuring that users can depend on it for multiple seasons of heavy use.

The cutting deck is another standout feature of the Craftsman 917.276920. With a 54-inch cutting width, it allows for fast mowing over large areas. The deck height is adjustable, providing users with the flexibility to achieve the perfect lawn height, whether they prefer a short, manicured look or a longer, more natural appearance. The mower also features a dual-blade system that further enhances cutting performance, ensuring a clean and even finish.

In terms of user comfort, the Craftsman 917.276920 is designed with ergonomics in mind. It comes with an adjustable high-back seat that provides support during long mowing sessions. The steering system is also user-friendly, featuring a smooth and responsive maneuverability that makes navigating tight spaces and obstacles easy. Additionally, the tractor's controls are intuitively placed for straightforward operation, reducing the learning curve for new users.

Another important feature of this lawn tractor is its versatility. The Craftsman 917.276920 is compatible with various attachments, including baggers, mulchers, and even snow blowers, allowing it to handle multiple tasks throughout the year. This adaptability makes it a valuable tool for homeowners looking to maintain their yards across seasons.

For those concerned about maintenance, the Craftsman 917.276920 includes features designed for easy upkeep. The engine is equipped with an easy-access oil fill and filter, simplifying routine maintenance. The cutting deck can also be easily removed for cleaning and servicing, ensuring that the mower stays in peak condition.

Overall, the Craftsman 917.276920 lawn tractor combines power, comfort, and versatility, making it an excellent choice for homeowners seeking a reliable solution for their lawn care needs. Its advanced features and technologies contribute to a practical and enjoyable mowing experience, allowing users to achieve professional-looking results in their own backyard.