Craftsman 917.28726 owner manual Battery, Fuel System, Engine OIL, Cylinders, Other

Page 28

Immediately prepare your tractor for stor- age at the end of the season or if the trac-

_i_ will not be used for 30 days or more.

WARNING: Never store the tractor

with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

When tractor is to be stored for a period

of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING"

in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary

(See belt replacement instructions in

the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws

are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage. After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see "TO

CLEAN BATTERY AND TERMINALS" in

the Maintenance section of this manual). After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using

ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio

found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carbure- tor. Do not empty the gas tank and carbu- retor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in

the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

,Do not store gasoline from one season to another.

,Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

,If possible, store your tractor indoors

and cover it to give protection from dust and dirt.

,Cover your tractor with a suitable pro- tective cover that does not retain mois-

ture. Do not use plastic. Plastic cannot

breathe which allows condensation to

form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Rrftsmrn SEARS, Roebuck and CO., Hoffman ESTATES, IL 60179 U.S.A90=DAYS on Battery Year on TractorGeneral Operation Service II. Slope OperationIV. Towing Safe Handling of GasolineGeneral Service Not use a nozzle lock-opendeviceSPECiFiCATiONS Sears Installation ServiceProduct For prices and additional information call 1=800=827=6655Adjust Seat Check BatteryUnpack Carton To Drive Tractor OFF Skid Check Tire PressureCheck Deck Levelness Check Brake System@@@ Know Your Tractor Service Reminder / Hour MeterAttachment Clutch Lever Stopping To Adjust Mower Cutting Height To Operate MowerUsing the Reverse Operation System To Operate on HillsTo Transport Transmission Engaged Transmission DisengagedTowing Carts and Other Attach Ments Before Starting the Engine Check Engine OIL LevelADD Gasoline To Start EngineAutomatic Transmission Warm UP RGE TRANSMiSSiONMowing TiPS Schedule MaintenanceGeneral Recommendations Tires Blade RemovalLubrication BeltsTo Change Engine OIL AIR Filter To Install Mower To Remove Mower03042 Precision SIDE-TO-SIDE Adjustment Visual SIDE-TO-SIDE AdjustmentFRONT-TO-BACK Adjustment To Level MowerTo Replace Mower Drive Belt To Start Engine with a Weak BAT- Tery Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order Engine To Adjust Choke Control To Adjust CarburetorBattery Fuel SystemEngine OIL CylindersProblem Cause Correction =ROBLEM Cause Correction VibrationInto reverse Operator leaves seat withRoblem Cause Correction Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXGarantia Servicio Funcionamiento General De amputar las manosy los pies y de lanzarIII. Niios IV. RemolquePage API-SG-SL Especificaciones DEL ProductoResponsabilidades DEL Cliente Ajuste EL Asiento Para Remover EL TractorLA Caja DE Carton Desempaque LA Caja DE CartonRevision DE LA Nivelacion DEL Remover EL Tractor DE LA PlataRevision DE LA Preskn DE LAS Llantas Conjunto@@@ Familiaricese CON SU Tractor SU TractorPalanca DE Control DE Movimien Palanca DE Mando CruceroComo Usar SU Tractor MientoParada Cuchillas DE LA Segadora Para Usar EL Control DE LA AOELER- AOI6N DAtras Utilizar EL Mando CruceroPara Ajustar LA Altura DE Corte DE LA Segadora Para Ajustar LAS Ruedas CALIBRADO- RASUsar EL Sistema DE Funcionamiento Atras Para Operar EN CerrosPara Transportar Antes DE Hacer Arrancar EL Motor Meoanismo DE Aviso DE Servicio / CRON6METROAgregue Gasolina MAS Arranque CON Tiempo TempladoArranque CON Tiempo FRO 50 Y Menos Calentamiento Para LA Transmision AutomaticaConsejos Para Segar Recomendaciones Generales Programa DE MantenimientoAntes DE Cada USO Llantas Verifiez Sistema Presencia OPERA- DORVerifiez Sistema Funcionamiento Atras ROS Cuidado DE LA CuohillaEnfriamiento DEL Transeje Nivel DEL Fluido DE LA Bomba DEL TransejeCorreas Motor LubricacionFiltro DE Aceite DEL Motor Filtro DE AirePara Darle Servicio AL Prefiltro Para Darle Servicio AL CartuchoPara Desmontar LA Cortadora DE Cesped TractorInstale LA Segadora Fije LA Pieza DE Union Anterior E Para Nivelar LA Segadora Regulacion Visual DE Lado a LadoLado Ajuste DE Delante a AtrasDesmontaje DE LA Correa Montaje DE LA Correa DE Transmision DE LA SegadoraMontaje DE LA Correa Controlar Y Ajustar EL Freno Control DEL FrenoIMPRESI6N / INCLINACI6N DE LAS RUE= DAS DelanterasPara Adjuntar LOS Cables DE Empalme Reemplazar LA BateriaPara Cambiar LA Bombilla DE LA LUZ Delantera Para Cambiar EL FusiblePara Ajustar EL Cable DE Control DE LA ACELERACI6N MotorPara Ajustar EL Carburador Baterja Aceite DEL MotorCjlindros OtrosIDENTIFICACI6N DE Problemas ProblemaPero noarranca CausaContinuado CORRECCJ6NCuando el operador Ma corte=dieparejoCausa Correccion Solamente Ande Cuesta Arriba O 15GRADOSMAXSears

917.28726 specifications

The Craftsman 917.28726 is a lawn tractor designed for both residential and light commercial use, making lawn maintenance a breeze. This robust machine is packed with features and technologies that enhance its performance, ease of use, and overall functionality.

One of the standout features of the Craftsman 917.28726 is its powerful engine. Equipped with a reliable 20 HP Briggs & Stratton motor, this tractor provides ample power to tackle tough mowing conditions and challenging terrains. Its automatic transmission allows for smooth acceleration and deceleration, making it ideal for users of all experience levels.

The 917.28726 comes with a 42-inch cutting deck, which is designed to handle medium to large lawns effectively and efficiently. The cutting height can be easily adjusted, providing versatility to manage different grass lengths. This feature ensures a clean and even cut, promoting the health and aesthetics of your lawn.

Another important characteristic of the Craftsman 917.28726 is its user-friendly design. The seat features a comfortable cushioning system and ergonomic armrests, making long mowing sessions much more enjoyable. The easy-to-reach controls are intuitively designed, allowing users to quickly adjust settings without interrupting their mowing rhythm.

Safety is also a priority with the Craftsman 917.28726. It is equipped with a safety switch that prevents operation when the operator is not in the seat, reducing the risk of accidents. Moreover, the tractor's strong build quality, reinforced frame, and reliable braking system provide peace of mind while operating on inclines or uneven surfaces.

The tractor also integrates modern technologies such as a quick-connect deck wash system, which simplifies maintenance and keeps the cutting deck clean for optimal performance. The heavy-duty tires provide excellent traction, ensuring stability on various terrains.

In conclusion, the Craftsman 917.28726 combines power, efficiency, and user-friendly features, making it an excellent choice for homeowners and light commercial users. With its durable construction, versatile cutting options, and safety enhancements, this lawn tractor stands out in the market, providing a reliable solution to meet your lawn care needs. Whether you are tackling your backyard or maintaining a larger property, the Craftsman 917.28726 delivers performance and reliability in every cut.
Top Page Image Contents