2.Slidemowerundertractor with deflec- tor shield to right side of tractor.
3.Lowerlift leverto its lowestposition.
4.Connectfront links to mowerdeck and securewith retainersprings.
5.Connectsuspensionarms to rear deck bracketsand secure with retainer springs.
6.
7.Push clutch cablehousingguide into
bracket,slide collar onto guide and securewith largeretainerspring.
8.Placeflat washerand clutchspring on
idlerpulley bolt and securewith small retainerspring.
9.Install belt onto engine pulley.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD- UCT SPECIFICATIONS" section of this
manual). If tires are over or underinflated,
you will not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
•Raise mower to its highest position.
•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other.
•If adjustment is necessary, make adjust- ment on one side of mower only.
•To raise one side of mower, tighten lift link adjustment nut on that side.
•To lower one side of mower, loosen lift
link adjustment nut on that side. NOTE: Each full turn of adjustment nut will change mower height about 1/8".
• Recheck measurements after adjusting.
Bottom edge | Bottom edge of |
of mower to | _, |
ground 7_._ | eJ_Agr°und |
| |
A_ | _ Ground Line |
| Arm |
Link |
|
Lidfustment | N_ |
front links equally so mower will stay level
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.
Check adjustment on right side of trac- tor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.
•Before making any necessary adjust- ments, check that both front links are equal in length.
•If links are not equal in length, adjust one link to same length as other link.
•To lower front of mower loosen nut "E"
on both front links an equal number of turns.
•When distance "D" is 1/8" to 1/2"
lower at front than rear, tighten nuts "F" against trunnion on both front links.
•To raise front of mower, loosen nut "F" from trunnion on both front links. Tighten
nut "E" on both front links an equal num- ber of turns. The two front links must
remain equal in length.
•When distance "D" is 1/8" to 1/2" lower
at front than rear, tighten nut "F" against trunnion on both front links.
•Recheck
Both | Should be :lual in Length |
=t"E"
mru
Front Links
22