Craftsman 917.273392 manual To Start Engine, ADD Gasoline

Page 15

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quan-

tities that can be used within 30 days to assure fuel freshness.

_)',CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: When operating in temper- atures below32°F(0°C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separa- tion and formation of acids during storage. Acidic gas can damage the fuel system

of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will

take extra cranking time to move fuel from the tank to the engine.

1.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

2.Place gear shift lever in neutral (N) position.

3.Move attachment clutch to disengaged position.

4.Move throttle control to choke position. NOTE: Before starting, read the warm and cold starting procedures below.

. Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do

not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50 ° F and above)

6.When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and

allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50 ° F and below)

6.When engine starts, leave throttle control in choke position until engine warms up and begins to run roughly. Once rough running begins, imme- diately move the throttle control to the

fast position. Engine warm-up may take from several seconds to several

minutes (the colder the temperature,

the longer the warm-up).

•The attachments can also be used dur- ing the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance (see "TO ADJUST CARBURETOR" in the Service and Adjustments section of this manual).

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Jcriiftsmiinj Limited Warranty on Battery Limited Warranty on Craftsman Riding EquipmentII. Slope Operation General OperationDo not IV. ServicePage Customer Responsibilities Product SpecificationsSears Installation Service U1RSteering Wheel SeatKeys To Remove Tractor from HOW to SET UP YOU R TractorTools Required for Assembly Install SeatCheck Battery Check Deck Levelness @@@@@ Attachment Clutch Lever Used Know Your TractorAlways operate engine at full throttle HOW to USE Your TractorTo SET Parking Brake To USE Throttle ControlBefore Starting the Engine To Operate On HillsTo Transport Towing Carts and Other Attach MentsADD Gasoline To Start EngineMulching Mowing Tips Mowing TipsLubrication Chart General RecommendationsBefore Each USE Blade Removal TractorBelts BatteryEngine Transaxle CoolingEngine Cooling System Clean AIR ScreenAIR Filter Engine OIL FilterTo Remove Mower CleaningTo Install Mower TractorSIDE-TO-SIDE Adjustment To Level Mower HousingTo Check Brake Belt InstallationTo Check and Adjust Brake Belt RemovalTo Attach Jumper Cables Transaxle Gear Shift Lever NEU- Tral AdjustmentFront Wheel TOE-IN/CAMBER To Start Engine with a Weak BAT- TeryTo Remove Hood and Grill AS- Sembly Replacing BatteryInterlocks and Relays To Replace FuseFinal Setting To Adjust Throttle Control CableTo Adjust Carburetor Preliminary SettingEngine OIL BatteryRemove mower from tractor for winter Fuel SystemTroubleshooting Chart Ignition switchHard to start Engine will not turn over Vibration Problem Cause CorrectionLoss of power ExcessiveCorrection DischargeHeadlights not Working If so equipped 0LAoK Tractor - Model Number SchematicElectrical Tractor - Model NumberKEY Part Description Tractor - Model Number ElectricalTractor - Model Number Chassis and Enclosures Tractor - Model Number Chassis and Enclosures Tractor - Model Number Ground Drive 875 Inches 1 inch = 25.4 mm Tractor - Model Number 917.273392 Steering Assembly Tractor - Model Number 917.273392 Steeringassembly Engine KEY Part Tractor - Model Number 917.273392 Seat AssemblyRH Stlt Tractor - Model Number DecalsTractor - Model Number Lift Assembly Tractor - Model Number Mower Deck KEY Part Description Numbers Here Part Description 515 O25 4-d O47 % 917.273392 Tractor Model Number309 693551 Motor-Starter 868 690968 Page Page Suggested Guide for Sighting Slopes for Safe Operation Get it fixed, at your home or ours

917.273392 specifications

The Craftsman 917.273392 is a robust and versatile lawn mower designed to meet the needs of homeowners who value efficiency, performance, and convenience. This model combines power and user-friendly features to ensure an optimal mowing experience.

One of the standout features of the Craftsman 917.273392 is its powerful engine. Equipped with a reliable Briggs & Stratton engine, it delivers exceptional cutting performance, making it ideal for various lawn types and sizes. The engine’s overhead valve design enhances fuel efficiency and provides better torque.

The cutting deck is another impressive aspect of this lawn mower. It features a wide 42-inch cutting deck that allows for quicker mowing of large areas. The deck is equipped with a dual-blade system, which guarantees a clean and precise cut. Additionally, the adjustable cutting height gives users the flexibility to choose their preferred grass length, accommodating different lawn care preferences.

In terms of convenience, the Craftsman 917.273392 does not disappoint. The mower includes a hydrostatic transmission, which provides seamless shifting without the need for a clutch. This feature ensures a smooth operation, allowing the user to focus on mowing rather than managing gears. The ergonomic design of the control panel enhances user comfort, with easy-to-reach levers for controlling speed and cutting height.

Safety is also a priority in the Craftsman 917.273392 design. The mower is equipped with a safety switch that automatically shuts off the engine when the operator leaves the seat, preventing accidents and enhancing peace of mind during operation.

Another valuable characteristic of this mower is its mulching capability. The optional mulching kit enables users to finely chop grass clippings, returning nutrients back to the soil, which can improve lawn health over time. The rear bagger option adds further versatility, allowing for efficient collection and disposal of grass clippings.

Maintenance has been made simpler with the inclusion of easy-access features. The mower deck can be easily cleaned without having to reach underneath, and regular maintenance tasks such as oil changes are straightforward.

Overall, the Craftsman 917.273392 combines power, versatility, and user-centric design elements, making it a reliable choice for homeowners looking to maintain a well-manicured lawn with ease.
Top Page Image Contents