Quick Start, Overall Wiring Schematic | Honeywell XYR 5000 LINE

2 Quick Start

This section summarizes what must be done in order to get the device installed, configured and in operation quickly. Additional detailed information is found throughout this guide. Steps 1-3 refer to the following diagram:

Figure 2-1 Overall Wiring Schematic

1.Wire 24VDC power to the Base Radio using the power terminals on either the WMT or the Modbus connection. Do not apply power to both sets of terminals.

2.Wire WMT RS-485 communications to the left terminal of the Base Radio.

3.Wire Modbus RS-485 communications to the right terminal of the Base Radio.

4.Place the terminating resistor between terminals A and B if the Base Radio will be used as an End Unit (See Section 3.2.7).

3

Image 10

Honeywell XYR 5000 LINE manual Quick Start, Overall Wiring Schematic

Contents

Base Radio User Guide XYR 5000 Line 34-XY-25-05 Rev 08/06Page Base Radio FCC Certification Contacts Revision NotesTelephone Table of Contents Quare R OOT F Unction Overall Wiring Schematic Table of Figures Introduction Using this ManualAbout the Device Unpacking Software Compatibility Overall Wiring Schematic Quick StartPage Mechanical Installation InstallationBase Radio Positioning General Layout Electrical Installation Electrical Specifications Terminal Block Labels Wiring Power to the Base Radio Wiring RS-485 to the Base Radio Wiring the RS-485/232 Converter to the Base Radio Wiring RS-485 to the Base Radio Wiring the RS-485/USB Converter to the Base Radio USB Driver Installation USB Converter’s Male DB-9 Connector Daisy-Chaining Multiple Base Radios to Single RS-485/PowerWiring the DB-9 RS-485 Cable to the Base Radio USB Driver Un-installation Daisy-Chaining Power to Multiple Base Radios Daisy-Chaining RS-485 to Multiple Base Radios Terminating Communications Wiring to the Base Radio Daisy-Chaining RS-485 to Multiple Base Radios Grounding the Base Radio High Gain Antenna Base Radio Displayed Messages General ConfigurationRead Only Sequence Overall Configuration Menu Map Read Only Sequence Setting the User Password Menu Map to Password Setting Configuring the RF Communications RF Channel Selection Menu Map to RF Baud Rate Setting RF Baud Rate Selection High RF ID Setting High Rfid Setting Base Radio Setup Modbus Baud Rate Setting Modbus Device ID Setting Menu Map to Modbus Baud Rate SettingPage Modbus Parity Setting Modbus Mapping Mode Setting Modbus Communication Protocol Regmode Command 03-Read Holding Registers Modbus CommandsCommand 08- Diagnostic Command 12- Get Com Event Log Command 11- Get Com Event CounterCommand 17- Report Slave ID Register Address Description Register Type Command 43- Read Device IDBase Radio Holding Registers Register Address Description Base Radio On/Offline Transmitter Registers Base Radio Device Type RegistersBase Radio Device Status Registers Value Base Radio Device Status Transmitter Holding Registers Device ID Mapping ModeRegister Mapping Mode Register Address Transmitter Device Type Holding Registers Value Device Type Transmitter Device Status Registers Alarm Condition WN571 onlySquare Root Function Value Transmitter Device Status Technical Specifications Overall Base Radio Dimensions Appendix a Navigating the Menus Appendix B Base Radio Menu Map Figure A- 1 Base Radio Menu Map Appendix C Modbus Register Definitions Page Page Page Honeywell