Technical Specifications | Honeywell XYR 5000 LINE instruction

7 Technical Specifications

Power Characteristics

•10VDC-30VDC, 24 VDC @ 200mA typical

RF Characteristics

•902 MHz – 928 MHz Frequency Hopping Spread Spectrum (FHSS), FCC certified ISM license-free band

•Up to 3000’ range to Transmitters with clear line of sight; 500’ to 1000’ range with obstructions

•The RF module in each Transmitter is individually tested and calibrated over the full temperature range to ensure reliable wireless operation

Output Options

•RS-485 digital communications with conversion to RS-232 or USB for interface with PC or server and WMT (WMT) (optional)

•Serial Modbus RTU (Binary) over RS-485

•Modbus over TCP/IP (via optional converter)

Physical Characteristic

•Baked enamel explosion-proof, weather-proof and corrosion-proof housing

•Electromagnetic Compatibility

•(CE Compliance)

•Operates within specification in fields from 80 to 1,000 MHz with field strengths to 10 V/m. Meets EN 50082-1 general immunity standard and EN 55011 compatibility emissions standard

Industrial Certification

•Rated for industrial use FM rated: -40°F to 185°F(-40°C to 85°C) CSA Rated: -40°F to 104°F(-40°C to 40°C)

•FM Approved as explosion-proof (XP) for Class I, Division 1, Groups B,C,&D, T6; as dust ignition-proof for Class II/III, Division 1, Groups E, F, &G, T6; indoor and outdoor (Type 4X) hazardous (classified) locations.

•CSA Approved as explosion-proof (XP) for Class I, Division 1, Groups B,C,&D, T6; as dust ignition-proof for Class II/III, Division 1, Groups E, F, &G, T6; indoor and outdoor (Type 4X) hazardous (classified) locations.

•NEMA 4X explosion-proof housing

34

Image 41

Honeywell XYR 5000 LINE manual Technical Specifications

Contents

XYR 5000 Line 34-XY-25-05 Rev 08/06 Base Radio User GuidePage FCC Certification Base Radio Telephone Revision NotesContacts Table of Contents Quare R OOT F Unction Table of Figures Overall Wiring Schematic About the Device Using this ManualIntroduction Software Compatibility Unpacking Quick Start Overall Wiring SchematicPage Base Radio Positioning InstallationMechanical Installation General Layout Electrical Specifications Electrical Installation Terminal Block Labels Wiring RS-485 to the Base Radio Wiring Power to the Base Radio Wiring RS-485 to the Base Radio Wiring the RS-485/232 Converter to the Base Radio USB Driver Installation Wiring the RS-485/USB Converter to the Base Radio Wiring the DB-9 RS-485 Cable to the Base Radio Daisy-Chaining Multiple Base Radios to Single RS-485/PowerUSB Converter’s Male DB-9 Connector USB Driver Un-installation Daisy-Chaining RS-485 to Multiple Base Radios Daisy-Chaining Power to Multiple Base Radios Daisy-Chaining RS-485 to Multiple Base Radios Terminating Communications Wiring to the Base Radio High Gain Antenna Grounding the Base Radio Read Only Sequence General ConfigurationBase Radio Displayed Messages Read Only Sequence Overall Configuration Menu Map Menu Map to Password Setting Setting the User Password RF Channel Selection Configuring the RF Communications RF Baud Rate Selection Menu Map to RF Baud Rate Setting High Rfid Setting High RF ID Setting Modbus Baud Rate Setting Base Radio Setup Menu Map to Modbus Baud Rate Setting Modbus Device ID SettingPage Modbus Mapping Mode Setting Modbus Parity Setting Regmode Modbus Communication Protocol Command 08- Diagnostic Modbus CommandsCommand 03-Read Holding Registers Command 17- Report Slave ID Command 11- Get Com Event CounterCommand 12- Get Com Event Log Base Radio Holding Registers Command 43- Read Device IDRegister Address Description Register Type Register Address Description Base Radio Device Status Registers Base Radio Device Type RegistersBase Radio On/Offline Transmitter Registers Value Base Radio Device Status Register Mapping Mode Device ID Mapping ModeTransmitter Holding Registers Register Address Value Device Type Transmitter Device Type Holding Registers Square Root Function Alarm Condition WN571 onlyTransmitter Device Status Registers Value Transmitter Device Status Technical Specifications Overall Base Radio Dimensions Appendix a Navigating the Menus Figure A- 1 Base Radio Menu Map Appendix B Base Radio Menu Map Appendix C Modbus Register Definitions Page Page Page Honeywell