Appendix a Navigating the Menus | Honeywell XYR 5000 LINE specs

Appendix A Navigating the Menus

Pressing either the NEXT or ENTER buttons located on the front of the Transmitter or Base Radio just below the Liquid Crystal Display (LCD) screen is all that is needed to navigate the respective menus. Pressing both of these buttons for one second will turn the unit on.

Pressing the NEXT button at any time while the Base Radio is cycling through the normal messages causes the Base Radio to enter the setup mode. The NEXT button is then used to step through menu options, and the ENTER button is used to enter a submenu of what is displayed on the LCD at that time. If no button is pressed within a 30 second period the unit goes back to the normal display mode.

If you enter a submenu that requires a numerical input, such as 001, the leftmost 0 will be blinking. This indicates that pressing the NEXT button will increment this value with each press from 0 to 9 and back to 0 again. Pressing the ENTER button will move to the next available value. If the last value is blinking, pressing ENTER will save the entered values and return to the return from the sub menu.

36

Image 43

Honeywell XYR 5000 LINE manual Appendix a Navigating the Menus

Contents

XYR 5000 Line 34-XY-25-05 Rev 08/06 Base Radio User GuidePage FCC Certification Base Radio Contacts Revision NotesTelephone Table of Contents Quare R OOT F Unction Table of Figures Overall Wiring Schematic Introduction Using this ManualAbout the Device Software Compatibility Unpacking Quick Start Overall Wiring SchematicPage Mechanical Installation InstallationBase Radio Positioning General Layout Electrical Specifications Electrical Installation Terminal Block Labels Wiring RS-485 to the Base Radio Wiring Power to the Base Radio Wiring RS-485 to the Base Radio Wiring the RS-485/232 Converter to the Base Radio USB Driver Installation Wiring the RS-485/USB Converter to the Base Radio USB Driver Un-installation Daisy-Chaining Multiple Base Radios to Single RS-485/PowerWiring the DB-9 RS-485 Cable to the Base Radio USB Converter’s Male DB-9 Connector Daisy-Chaining RS-485 to Multiple Base Radios Daisy-Chaining Power to Multiple Base Radios Daisy-Chaining RS-485 to Multiple Base Radios Terminating Communications Wiring to the Base Radio High Gain Antenna Grounding the Base Radio Base Radio Displayed Messages General ConfigurationRead Only Sequence Read Only Sequence Overall Configuration Menu Map Menu Map to Password Setting Setting the User Password RF Channel Selection Configuring the RF Communications RF Baud Rate Selection Menu Map to RF Baud Rate Setting High Rfid Setting High RF ID Setting Modbus Baud Rate Setting Base Radio Setup Menu Map to Modbus Baud Rate Setting Modbus Device ID SettingPage Modbus Mapping Mode Setting Modbus Parity Setting Regmode Modbus Communication Protocol Command 03-Read Holding Registers Modbus CommandsCommand 08- Diagnostic Command 12- Get Com Event Log Command 11- Get Com Event CounterCommand 17- Report Slave ID Register Address Description Command 43- Read Device IDBase Radio Holding Registers Register Address Description Register Type Value Base Radio Device Status Base Radio Device Type RegistersBase Radio Device Status Registers Base Radio On/Offline Transmitter Registers Register Address Device ID Mapping ModeRegister Mapping Mode Transmitter Holding Registers Value Device Type Transmitter Device Type Holding Registers Value Transmitter Device Status Alarm Condition WN571 onlySquare Root Function Transmitter Device Status Registers Technical Specifications Overall Base Radio Dimensions Appendix a Navigating the Menus Figure A- 1 Base Radio Menu Map Appendix B Base Radio Menu Map Appendix C Modbus Register Definitions Page Page Page Honeywell