Honeywell XYR 5000 LINE manual Base Radio, FCC Certification

Base Radio

Models: WBR-AK

Versions 1.70 or later

Important Information for the User

•Changes or modifications not expressly approved by the manufacturer may void the user’s authority to operate the equipment.

•This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1This device may not cause harmful interference.

2This device must accept any interference received, including interference that may cause undesired operation.

•This device is for mobile and fixed use only (not portable or body-worn). A separation distance of 20cm must be maintained at all times between the antenna and the body of the user and bodies of nearby persons.

•If the WMT (RF Server) software is shutdown, the RS-485 network MUST be physically disconnected from the PC as the serial port is no longer being controlled by the software and may disrupt communications between multiple Base Radios.

•This device has been designed to operate with an antenna having a maximum gain of 9 dBd. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.

•To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP (Equivalent Isotropically Radiated Power) is not more than that required for successful communication.

•The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s website www.hc-sc.gc.ca/rpb.

FCC Certification

•This product is a frequency hopping RF transceiver module for the 900 MHz ISM band, designed to meet FCC 15.247, and is used in industrial control and monitoring applications.

•The antenna is factory installed and MUST NOT be removed or modified by user. This document cannot be changed without prior FM approval

Honeywell Inc.

Industrial Measurement and Control

2500 West Union Hills Drive

Phoenix, AZ 85027

Copyright 2006 by Honeywell International Inc.

Rev. 4- 08/30/2006

While this information is presented in good faith and believed to be accurate, Honeywell disclaims the implied warranties of merchantability and fitness for a

particular purpose and makes no express warranties except as may be stated in its written agreement with and for its customers.

In no event is Honeywell liable to anyone for any indirect, special or consequential damages. The information and specifications in this document are subject to

change without notice.

Honeywell® and TotalPlant® are U.S. registered trademarks Of Honeywell International Inc.

Other brand or product names are trademarks of their respective owners.

III