Craftsman 917.272068 owner manual Other, Fuel System, Engineoil, Cylinders

Page 29

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

CAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Mainte- nance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BA'I-rERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see 'q-OCLEAN BATTERY AND TERMI- NALS" in the Maintenance section of

this manual).

After cleaning, leave cables discon- nected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage.

Also, alcohol blended fuels (called

gasohol or using ethanol or methanol) can attract moisture which leads to

separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or

storage container. Always follow the mix ratio found on stabilizer container. Run

engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach

the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer,

ENGINEOIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain

moisture. Do not use plastic. Plastic cannot breathe which allows conden-

sation to form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

29

Image 29
Contents Sears Craftsman Help Line 5 am 5 pm, Mon- Sat JcrrftsmrniSears Limited 90 DAY Warranty on BatteryGeneral Operation II. Slope OperationDo not IV. ServiceIII. Children Page API-SF-SJ Product SpecificationsRC12YC Repair Agreement16-18 Check Battery Tools Required for AssemblyCarton Before Removing Tractor from Skid Attach Steering WheelInstall Seat Check Brake System Ixl Freewheel Control Knowyour Tractor Your TractorThrottle HOW to USE Your Tractor To SET Parking BrakeContr Parking StoppingTo Operate Mower Gauge Wheel Mountinc LocknutDeflector To Operate on HillsBefore Starting the Engine Check Engine OIL Level Towing Carts and Other ATTACH- MentsADD Gasoline To Start EnginePurge Transmission Automatic Transmission Warm UPMulching Mowing Tips Mowing TipsGeneral Recommendations Lubrication ChartBefore Each USE BearingBrake Operation BatteryTires Operator Presence SystemTransaxle Cooling EngineTransaxle Pump Fluid LubricationClean AIR Screen To Service PRE-CLEANERCleaning Engine OIL FilterTo Install Mower Service or AdjustmentsTo Remove Mower ArmsRecheck measurements after adjust- ing To Level Mower HousingMower to GroundTo Adjust Brake Belt InstallationTo Replace Mower Blade Drive Belt IdlerTransaxle Motion Control Lever Neutral Adjustment To Adjust Steering Wheel ALIGN- MentTransmission REMOVAL/REPLACE- Ment Front Wheel TOE-IN/CAMBERReplacing Battery To Start Engine with a Weak BatteryTo Replace Headlight Bulb Interlocks and RelaysToremovehood and Grill AS Sembly To Adjust THROnLE Control CableTo Adjust Carburetor Clamp AdjustingAcceleration Test Fuel System OtherEngineoil CylindersCause Correction ProblemProblem Cause Problemcause Tractor - Model Number Schematic Electrical Tractor - Model NumberKEY Part Description Tractor - Model Number ElectricalTractor --MODEL Number Chassis and Enclosures Tractor - Model Number 917.272068 Chassisand Enclosures Tractor --MODEL Number Ground Drive Keeper, Center Span Tractor - Model Number Steering Assembly KEY Part NO. NO,DESCRIPTION Spark Arrester Tractor - Model Number EngineOptional Equipment KEY Part NO. NO. Description Tractor -- Model Number EngineKEY Part Description Tractor --MODELNUMBER Seat AssemblyWheels & Tires DecalsTractor - Model Number Liftassembly Tractor - Model Number Lift Assembly Tractor - Model Number Mower Deck Shaft Assembly, Mandrel, Vented ¢ C 71idx1.15odx.030thk Cylinder HEAD, Valve and Breather Crankcase KEY Part Description AssemblyIGNITION/ELECTRICAL Blower Housing and Bafflesi AIR Intake AIR INTAKE/FILTRATION Gasket, air cleaner12-743-12-S 12-094-14-SStarting System Engine Controls OIL PAN / Lubrication KEY Part NO. no KEY Part NO. NO,DESCRIPTIONKEY PAR NO. NO.DESCRIPTION Exhaust Inches 1 inch= 25.4 mm DESCRIPrlONPage Page Page Suggested Guide for Sighting Slopes for Safe Operation A. and Canada Your Home

917.272068 specifications

The Craftsman 917.272068 is a highly efficient and robust lawn tractor designed to meet the needs of both homeowners and professional landscapers. Built with durability and performance in mind, this machine is ideal for tackling a variety of mowing tasks, whether you have a small residential lawn or a more expansive grass area.

One of the standout features of the Craftsman 917.272068 is its powerful 24 HP engine, which provides ample power to handle tough mowing conditions. The engine is specifically designed for reliability and longevity, ensuring that it can provide consistent performance over many seasons. Coupled with the dual blade system, the mower provides an even and clean cut, reducing the need for double mowing and optimizing efficiency.

The 917.272068 is equipped with a 42-inch cutting deck, allowing for wide swath mowing while maintaining agility around obstacles. The cutting height is adjustable, providing users with the flexibility to choose from various settings, ensuring a tailored cut to suit the season or grass type. This versatility makes it particularly advantageous for users with varying mowing preferences and lawn conditions.

Another notable feature is the hydrostatic transmission, which allows for smooth and effortless control of speed and direction. This feature enhances ease of use, particularly for those who may not be accustomed to operating larger machinery. The responsive controls enable precise maneuverability, making it possible to navigate tightly spaced areas with ease.

The Craftsman 917.272068 also includes comfortable seating and a user-friendly dashboard that displays essential information at a glance, such as fuel level and maintenance reminders. This focus on operator comfort is a crucial aspect of its design, making long mowing sessions more enjoyable and less fatiguing.

In terms of technology, the Craftsman 917.272068 supports mulching and rear discharge capabilities, providing users with the option to either recycle grass clippings back onto the lawn for nutrient replenishment or easily discharge clippings behind the mower. This dual functionality enhances the utility of the mower, catering to different user preferences and lawn care practices.

Overall, the Craftsman 917.272068 stands out with its fusion of power, efficiency, and user-friendly features. Its reliable performance, combined with adjustable mowing options and comfortable operation, positions it as a top choice for anyone looking to achieve a well-maintained lawn. Whether for residential use or professional landscaping, this lawn tractor is built to deliver excellent results season after season.