Craftsman 917.27242 Clean AIR Screen, Clean AIR INTAKE/COOLING Areas, AIR Filter, Muffler

8.Use gauge on oil fill cap/dipstick for checking level. Insert dipstick into the

•tube and rest the oil fill cap on the tube. Do not thread the cap onto the

tube when taking reading• Keep oil at "FULL" line on dipstick. Tighten cap onto the tube securely when finished.

Oil DrainValve

Closed

and

Locked

Position

Cap

Drain Tube

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

CLEAN AIR INTAKE/COOLING AREAS

To insure proper cooling, make sure the

grass screen, cooling fins, and other external surfaces of the engine are kept clean at all times.

Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary.

Make sure the cooling shrouds are reinstalled.

NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.

AIR FILTER

Your engine wilt not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every

100hours of operation or every season, whichever occurs first.

Service air cleaner more often under

dusty conditions.

1.Remove knob and cover.

2.Remove wing nut and air cleaner from base.

TO SERVICE PRE-CLEANER

3.Slide foam pre-cleaner off cartridge.

4.Wash it in liquid detergent and water.

5.Squeeze it dry in a clean cloth. Allow it to dry.

6.Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.

TO SERVICE CARTRIDGE

•Replace a dirty, bent, or damaged cartridge.

NOTE= Do not wash the paper cartridge or use pressurized air, as this will damage the cartddge.

7.Reinstall the pre-cleaner (cleaned and oiled) over the paper cartridge.

8.Reassemble air cleaner, wing nut, cover and tighten knob securely.

Air Cleaner	.Cover
	Knob
Foam	Nut
Pre-	Rubber

Paper

Cartridge

_ir Cleaner

Base

Screen

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS" section of this manual.

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

1.Drain oil from engine crankcase (See

"TO CHANGE ENGINE OIL" in this section of this manual, through step remove drain plug).

2.Remove oil filter and wipe off filter adapter.

21