Craftsman 917.27339 owner manual Replacing Battery, Interlocks and Relays, To Replace Fuse

Page 25

2.Connectone end of the BLACKcable

to the NEGATIVE(-) terminal(C) of fully chargedbattery.

3.Connectthe other end of the BLACK

cable(D) to good chassisground, awayfrom fuel tank and battery.

TO REMOVECABLES,REVERSE ORDER -

1.BLACKcablefirst from chassisand then from the fully chargedbattery.

2.REDcable lastfrom both batteries.

 

02614

Weak or Dead

Fully Charged

Battery

Battery

REPLACING BATTERY

_,WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at

the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

1.Lift seat pan to raised position.

2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

3.Install new battery with terminals in same position as old battery.

4.First connect RED battery cable to positive (+) terminal with hex bolt and

keps nut as shown. Tighten securely. Slide terminal cover over terminal

5.Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

Seat Pan

Terminal

Cover(_/Keps

_ Nut Hex

Bolt

(Red)

CableNegative (Black) Cable

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the grill.

3.Replace bulb in holder and push bulb holder securely back into the hole in

the backside of the grill.

4. Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause

your tractor to run poorly, stop running, or prevent it from starting.

• Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL AS- SEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

4.When replacing hood, be sure to re- connect the headlight wire connector.

Hood

Headlight Wire

Connector

25

Image 25
Contents Jcriiftsmiinj Limited Warranty on Battery Limited Warranty on Craftsman Riding EquipmentGeneral Operation II. Slope OperationIII. Children IV. ServiceDo not Page Repair Protection Agreements Product SpecificationsSeat Steering WheelKeys Slope Sheet Video Cassette Assemble Extension Shaft and Boot Tools Required for AssemblyTo Remove Tractor from Unpack CartonCheck Battery Check Brake System Install Mulcher PlateDischarging Check Tire Pressure@@@@@ Ammeter Know Your TractorLift Lever Throttle reduces the battery charging rate HOW to USE Your Tractor To SET Parking BrakeTo USE Throttle Control Always operate engine at full throttleDo not drive up or down To Operate On HillsTo Transport Towing Carts and Other Attach MentsADD Gasoline To Start EngineMulching Mowing Tips Mowing TipsGeneral Recommendations Lubrication ChartBefore Each USE Operator Presence System TractorBlade Removal Engine BatteryTransaxle Cooling BeltsAIR Filter Clean AIR ScreenEngine Cooling System Spark PlugsTo Install Mower CleaningTractor To Remove Mower SIDE-TO-SIDE Adjustment To Level Mower HousingTo Check and Adjust Brake Belt InstallationTo Check Brake Belt RemovalTransaxle Gear Shift Lever NEU Tral Adjustment To Adjust Steering Wheel Align MentFront Wheel TOE-IN/CAMBER To Start Engine with a Weak BAT TeryInterlocks and Relays Replacing BatteryTo Replace Fuse To Remove Hood and Grill AS- SemblyPreliminary Setting To Adjust Throttle Control CableFinal Setting To Adjust CarburetorEngine OIL BatteryCylinders OtherProblem Troubleshooting ChartEngine will not turn over Engine clicks but will not start Loss of power ProblemExcessive VibrationMower blades will Battery will NotNot rotate Poor grassBlack Tractor - Model Number SchematicTractor - Model Number Electrical KEY Part NO. NO. Description Tractor - Model Number 917.273390 Chassis and Enclosures 20fKEY Part Description Tractor - Model Number Ground Drive 7ooKEY Part Tractor - Model Number 917.273390 Steering Assembly KEY Part Description Engine Tractor - Model NumberOptional Equipment Tractor - Model Number Seat Assembly KEY Part Tractor - Model Number DecalsWheels &TIRES KEY Part Description Tractor - Model Number Lift Assembly Tractor - Model Number Mower Deck KEY Part NO. NO.DESCRIPTION 15729B Part Description 20@ 7Sv5 108A 917.273390 Tractor Model NumberBriggs ENGINE-MODEL Number KEY Part NO. NO.DESCRIPTION Description Page Page Suggested Guide for Sighting Slopes for Safe Operation AR 0 4,0

917.27339 specifications

The Craftsman 917.27339 is a versatile riding lawn mower designed for homeowners seeking efficiency and performance in lawn maintenance. This model boasts a robust build quality, making it a popular choice among gardening enthusiasts and professional landscapers alike.

One of the standout features of the Craftsman 917.27339 is its powerful 26-horsepower Kohler engine, providing ample power for tackling a variety of lawn sizes and terrains. The engine ensures reliable performance and longevity, making it suitable for both residential use and larger landscapes. The mower is equipped with a hydrostatic transmission, which allows for smooth speed transitions without the need for shifting gears, making it easy to maneuver around obstacles and varying terrains.

The cutting deck is another highlight of the Craftsman 917.27339. With a 54-inch cutting width, it is designed to efficiently handle large mowing areas, reducing the time required to complete lawn care tasks. The deck features a 12-gauge steel construction, which increases durability and allows for effective grass cutting and collection. The adjustable cutting height, ranging from 1.5 to 4 inches, provides users with flexibility, enabling them to achieve the desired lawn finish.

In terms of technology and user convenience, the Craftsman 917.27339 is equipped with an ergonomic seat and steering wheel, promoting comfort during extended use. The mower also features an easy-to-access control panel that provides essential information at a glance, including speed and fuel levels.

For those concerned about grass clippings, this model includes a rear discharge option, which helps to distribute clippings evenly across the lawn, promoting healthier grass growth. Additionally, the optional bag attachment allows for easy collection of clippings, keeping your yard neat and tidy.

The Craftsman 917.27339 stands out not only for its performance but also for its ease of maintenance. It features quick-change oil and air filters, allowing users to perform routine upkeep without hassle. With its combination of power, comfort, and cutting-edge features, the Craftsman 917.27339 is an ideal choice for anyone looking to maintain a beautiful, well-manicured lawn with minimal effort.