Craftsman 358.798260-32cc manual ST O a Warmenoinbthathas, STAITINGINSTRUCTIONSFor location

Page 12

C. STAITING'INSTRUCTIONS(For location

BEFORE STARTING THE ENGINE:

eFuel engine. Move 10 feet (3 meters) away from fuel- ing site.

The trimmer head will turn when the engine starts.

•Rest engine and shield on ground, supporting trim-

:mer head off ground.

Remove and discard the plastic shipping guard on the primer bulb (if so equipped).

STARTING A COLD ENGINE OR WARM ENGINE

AFTER RUNNING OUT OF FUEL:

•Make sure the switch is in the "On" position.

•Move the choke lever to the "Full Choke" position,

•Slowly press the primer bulb 6 times.

•Squeeze and hold the throttle trigger. Keep the throttle trigger fully squeezed until the engine runs

smoothly.

•PulI starter rope sharply 5 times.

NOTE." The engine may sound as ifitistryin_to start before the 5TM pull. If so, go to the next step :m- mediately.

•Move the choke lever to the "Half Choke" position.

•Pu_:the starter rope sharply until the engine runs, but no more than 6 pulls.

If the engine has not started al_er 6 pulls (at half choke), check to make sure the switch and the choke lever are in the proper positions. Then, move the choke lever to the "Full Choke" position and press the primer bulb 6 times; squeeze and hold the

throttle trigger and pull the starter rope 2 more times. Move the choke lever to "Half Choke" and pull

the starter rope until the engine runs, but no more than 6 more pulls.

NOTE.* Ifthe enginestillh,asnot Started,itisprob- ably flooded. Proceed to Startinga Flooded Eno

gine."

• • r

i

i

illll

of controls, refer to "Specifications")

• Squeeze and hold the throttle trigger. Keep the

throttle trigger fully squeezed until the engine runs • smoothly.

•Pull starter rope sharply until engine runs, but no more than 5 pulls.

•Allow the engine to run 15 seconds, then move the choke lever to "Off Choke."

NOTE." Ifenginehas notstarted,pullstarterrope5 more pulls.Ifenginestilldoes notrun,itisprobably flooded.Proceedto"Startinga FloodedEngine."

To stoptheengine,move switchtothe"Off"position.

STARTING A FLOODED ENGINE: " •

Floodedenginescan be startedby placingtheswi,:tch inthe "On '_positionand the choke leverinthe Off

Choke" position;then,pullthe ropeto cleartheen-

gine of excessfuel.This couldrequirepullingthe

starterropemany timesdependingon how badlythe unit is flooded.

If the unit still doesn't start, call the Customer Assis- tance Hotline at 1-800-235-5878,

! STARTING POSITION t

Switch

Allow the engine to run 15 second_, then move the

chokelever to "0ffChoke." AHow the unit torun for

Choke Lever

30 more seconds at "Off Choke" before releasing the

throttle trigger.

.................

]N_Q_rEI Ifengine dies with the choke lever at the "Off

Choke" position, move the choke lever to "Half Choke" and pull the rope until the engine runs.

To stopthe engine,move the switchto "Off."

A WARNING

Avoid any bodily contact with the muffler when

starting a warm engine. A hot muffler can cause

serious burns.

ST O A WARMENOINB'THATHAS

Rt_ OUT OF FU'_L,

•Make sure the switch is in the "On" position.

•Move the choke levertothe "HalfChoke" position.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents SE,/AIk /S£RRFTSMRN Contents SpecificationsThrown Blade can SeriouslyCUT YOU OlOR Others InstructionsStore unit and fuel in an area where fuel vapors Always Engine Right-hand SideHands Store the unit out of reac2x of childrenCarton Contents Know Your ToolUnpacking Instructions KEYCustomer Responsibilities section TubeRidgeand bottom Throttle Not Kink ThrottleSheath until HandlebarFor Line Trimmer USE TowardTrimmerAwarnig Fiat washer WasherAs shown in lower inset See insetSHOULDgl STR.Ar ShoulderstrapPosition Handlebar for Fueling Your Engine Before Fueling EngineGasoline Cycle OILControls, refer to Specifications Make sure the switch is in the On positionST O a Warmenoinbthathas STAITINGINSTRUCTIONSFor locationOperating Instructions Stop Coasting Blade By Contact with Cut MaterialUsing Your Tool AS a Weedcutter wfBLADE FootIng cut. By using the tool properly, the occurrence RapimyWill be less likely to lose control Using Your Unit AS a Line Always wear eye protection, when operatingTrimmer Maintain ControlTrimmer Line Advance Line Replacement TrimmingScalping MowingInstalling Line on Spool SpoolReplacementAccessories Stock noFace Shield 18613 530-030102Safety Customer ResponsibilitiesWarnv G ICETrouble Shooting Suggestions €. Acceleration CheckFourClutch Shroud Screws shown Rn€Starter Circle ScrewSpark plug before per Cutting Edges Become Dull,Check Blades for FilterGAS TRIMMER/BRUSHCUTTER Storage Instructions Season or if it witl not be used for 30 days or moreTrouble Shooting Only for a fewLine Drive Shaft Housing FI.EXIBI,E Drive ShaftOperators Manual 358.798260 32cc Gas WeedwackerCortadora DE Hierbas Motor de 2 tiemposMantenimiento Piezas de repuestoLnterr uptoit,,embrague NOTAt Laserline ES UNA Marcade FAItRICAIo81!.niutl0ry Tanouede CombustibleAXADVERTENCIA AadvertenciaAadvertencia AdvertenciaServicioAutorizado No filmeFume cerca Atcanzar a hfspasAintroduccion Contenido DE LA CajaBinstrucciones Para Desempacar £. B. -C. DPasos Para EL Armado Refer to illustrations PreparacionCable DEL Acelerador Mangode ApoyoDel cable Pbd6-n--recffiPara Usar LA Cortadora CON Linea LlaveEl largo Del escudo Hacia el iado del motorLrilnddilbi ¢hldi!,lilaranddilpluniy Hojta Para USO CON Hoja Cortadora DE HierbasArandela G Posicion DE Operacion En su espalda Direcci6n de la rotaci6nSitue EL Manubrio Para LA Altura DE LA Operacion Mis de De 6 aCargando Combustible a SU Motor CombustibleEstabilizador DE Combustible Tabla DE Mezcla DE CombustibleCucrl ill zrrzmcurun m0tqlrtzdicnt ,Un 8ilenciador alicnt Antes DE Arrancar EL MotorPalanca del estrangulador Pcrill8 delNotas Instrucciones Para LA OperacionUcidcntihncntD ¢.tcngu, Inhoja dtind01acn contact0fn Advertenci Zona DE PeligroLA Hoja Continua La hoiaSeguridad DE LA Hoja La htjtropicza, sc atasca, 0 sc pega. Esto sude sucederCuidese DEL Rebate DE LA Hoja QUE Causa EL Rebate DE LA HojaAdvertencia Objetos Disparados Advertencia Zona DE PeligroAdvertencia Cabeza DE LA SeguridadMetodos Para Cortar El sueloReemplazo DE LA Linea Sobre Ei suelo La pdnta de ta llnea es la que cortaLas plezas daiiadas antes de usar la herramlenta Aleta de seguroIiit!In6 lit La ortad0nSeguro CarreteAccesorios DE PiezaResponsabilidades DEL Operario Seguridad DEL MantenimietoLubricacion DEL EJE DE Propulsion Flexible Sugelrencias Para EL Diagnostico DE Problemas Regulacion DEL CarburadorRegulaciones Basicas DEL Carburador Sigit las instruct!ones en hi seCci6n d, Rcvisi6n dc litCuerda Para Arrancar PELIGI#OMotor, 1o que puede causarle serios La bujiaCremallera CfrculTuerca De 5/32 la poleaFiltro DE Aire Afilado DE LA HojaPara mantener el equitibrio de ta hoja Advertencia Motor y dd cseulest+ntodavfa c+lientcsOtras Inmediatamente para almacenar al final de la temporadaAfilath Tabla DE Diagnostico DE Problemas CausaNotas Notas Preparacion Carga DE CombustibleArrancando EL MotorManual del Operario 358.797260-32cc

358.798260-32cc specifications

The Craftsman 358.798260 is a versatile 32cc gas-powered string trimmer that offers both power and precision for residential and professional lawn care. Designed for those who require efficiency without sacrificing comfort, this trimmer stands out with its blend of innovative technologies and well-thought-out design features.

One of the main highlights of the Craftsman 358.798260 is its robust 32cc two-cycle engine. This powerful engine facilitates easy cutting through thick grass and stubborn weeds, providing reliable performance for various outdoor tasks. The engine is tuned for efficient fuel consumption, allowing users to maximize their operational time while minimizing refueling interruptions.

Equipped with an easy start technology, this trimmer allows users to start the engine with minimal effort, reducing pull starts. This feature is particularly beneficial for those who may struggle with traditional starting mechanisms. Additionally, the Craftsman 358.798260 boasts a lightweight design that enhances maneuverability and reduces user fatigue, allowing for long periods of use without discomfort.

Another notable characteristic of the Craftsman 358.798260 trimmer is its 18-inch cutting path. This provides a broad area for cutting, significantly improving efficiency while trimming around edges, flower beds, and other hard-to-reach areas. The trimmer head is designed with a dual line, which ensures that weeds and grass are cut cleanly and effectively, ensuring a neat finish.

For enhanced user control, the Craftsman 358.798260 features an adjustable dual handle system that allows users to change their grip for optimal comfort and balance. This feature helps users maintain control over the trimmer, whether they are working at ground level or accessing higher areas.

Additionally, the trimmer is designed with durability in mind, featuring high-quality materials that withstand the rigors of regular use. The anti-vibration technology integrated into the design helps to reduce operator fatigue, making it suitable for extended use without discomfort.

In summary, the Craftsman 358.798260 string trimmer is a powerful, efficient, and user-friendly outdoor tool that meets the demands of both homeowners and professionals alike. With its strong engine, lightweight design, and ergonomic features, it offers an optimal balance of power and precision for achieving a well-maintained landscape.
Top Page Image Contents