ASSEMBLY
(If toolis received assembled, repeat all steps in this justed for the operator.)
PREPARATION
This Manual is designed to help you assemble the tool and to provide its safe operation. It is important that you read the entire manual to become familiar with the tool before you begin assembly. If you have any
questions or need further assistance, call our
CUSTOMER ASSISTANCE HOTLINE at
1. Read your Operator's Manual _
2.Tools you will need:
-Hex Wrench provided with the tool.
-Adjustable Wrench
-Standard Screwdriver
ASSEMBLY STEPS (Refer to illustrations)
TUBE
•Place the two screws "A." into the holes on the
engine as shown in the illustration. Make sure screws are fully seated in the holes.
•Position the. nuts. "l. "in the lower holes.
•• Tighten the screws with the hex wrench (pro-
vided) just enough to hold the hardware to-
gether while holding the locknuts with your other hand.
•Remove the pacldng cover from the straight end of the shaft housing if so equipped. Your unit may not have a packing cover.
Make sure the shaft inside the tube does not fall out of the tube. Dirt on the shaft will sig- nificantly reduce the life of the unit. If the drive
shaft falIs out ofthe housing, clean,
and
the Customer Responsibilities section.
•Align the'_bottom groove on the tube with the ridge on the lower wail of the engine opening.
•Turn the shaft to align the square end of the shaft with the square hole inside the front opening of the engine.
•Firmly push the tube into the engine opening until the top groove is no longer visible.
•Tighten screws "A." alternately with the hex wrench until secure.
section to be sure assembly is correct pad is ad-
:i
| . | . ' • | , • |
Screw | "A" |
|
|
| that may be on the end of the |
,__ | / | tube. |
Remove an, packin, materi._ " |
Ridgeand bottom
groove
Turn the arbor shaft to align the shaft with the square hole.