Operating Instructions
DANGER
DO NOT attempt to unclog the snowblow- er or make any adjustments with the trac- tor engine running. Disengage the PTO clutch, stop the engine, and remove the ignition key.
DANGER
NEVER place hands in the blower spout. DO NOT use hands or feet to unclog the snowblower. Use a short stick or similar tool to remove any clogged material.
The following list of items should be checked if a pat- tern of clogging begins to develop. All of these items are capable of causing clogging.
•Check that the inside of the snowblower housing is clean and free of snow and/or ice buildup.
•Check that the auger is in good condition and not bent, both the auger flighting and the center pad- dles.
•Check the inside of the blower spout for smooth- ness and freedom of obstruction.
Remember, anything that restricts airflow or materi- al flow along the entire path from the auger to the blower spout can cause clogging.
DEBRIS BLOWER CONTROLS
Chute Rotation Handle
The chute rotation handle is located on the rear of the debris blower, on the upper RH side of the im- peller housing. The chute rotates in a 230 degree arc, by cranking the rotation handle. Turning the handle clockwise rotates the chute clockwise. Turning the handle counterclockwise rotates the chute counterclockwise.
Chute Rotation
Handle
Chute Rotation Handle
Deflector Position Control Knob
Set the angle of the deflector according to the dis- tance the debris must be thrown. To adjust the de- flector angle, loosen the knob on the RH side of the deflector, slide the deflector to the required angle, and securely retighten the knob.
Deflector Position
Control Knob
Deflector Position Control Knob
DEBRIS BLOWER OPERATION
CAUTION
Before operating the debris blower, read and understand all Safety Instructions and
Operating Instructions.
Raising and Lowering the Debris Blower
Refer to Implement Lift Switch in this section.
41