Woods Equipment MZ2252K manual Height of CUT, Rear Deck Rollers, Front Deck LIP

Page 35

WOODS

ADJUSTMENTS

HEIGHT OF CUT

The height of cut is set by moving height of cut pin C to the hole designated for the height of cut desired.

To change the height of cut:

1.Lift the deck to the highest position.

2.Move pin C to the selected hole.

3.Lower the deck until the lift lever is stopped by the pin.

NOTES:

–Height of cut may vary due to the amount of tread on the tires, tire diameter or inflation pres- sure.

–For best results, adjust the rear deck rollers for the height of cut to be used (see below).

REAR DECK ROLLERS

The rear outside deck rollers are adjustable up and down to provide improved deck flotation and scalp- ing protection at various heights of cut. They are not intended to ride continuously on the ground. Adjust no closer than 3/8" (10mm) to the ground.

Height of cut ranges for roller adjustment

FRONT DECK LIP

Adjustable front deck lips have been provided on 52 in. and 61 in. cutterdecks for various cutting condi- tions.

To revise per conditions:

1.Loosen the front bolts S.

2.Adjust height of H.

3.Retighten S once you have desired height.

35

Image 35

Contents OPERATOR’S Manual Wash Hands After Handling CaliforniaAlitec BMP Central Fabricators Gannon Gill WAIN-ROY Woods Important MessageTo the Dealer To the OwnerTable of Contents Become Alert SafetyPreparing for Safe Operation Starting Machine Operation Operating SafelyGeneral Maneuvering Safely Interrupting operationSeat Belt Useage Mowing SlopesHydraulic System Maintenance Safety GeneralBlades FuelJump Starting BatteryStorage Safety Labels OFF LH Tank RH Tank Hydraulic OIL Operators Manual is Located Under the Foot PlateTRANSPORT5 NN N At operators right side ControlsTurns during reverse movement Lift and traction levers operators right sideTurns during forward movement Foot Lift Pedal Compartment beneath the seat Viewed from above Pushing the MachineParking brake in on position Operators left side PRE-OPERATION Check List OWNER’S Responsibility PRE-OPERATION Check ListOperator Presence Interlock System OperationFueling Before Starting the EngineDriving Operating NotesCutting Tips CuttingMachine Maintenance ChartEngine HydraulicsGeneral Maintenance RecordCheck Daily MaintenanceBattery Lubrication Periodic OIL Changes Hydraulic SystemAfter First Five 5 Hours Fuel Filter Engine OILSpark Plugs Engine Cooling Heavy Duty Cyclonic AIR CleanerTo replace air cleaner elements Washing Machine Cleaning MachineBlade Balance Blade InstallationBlade Removal SharpeningCounterbalance Springs AdjustmentsDeck Leveling Front Deck LIP Height of cut ranges for roller adjustmentHeight of CUT Rear Deck RollersFor clarity brake in on position Parking brake assembly tire and deck not shownControl Levers Parking BrakeReverse Return Hydrostat AdjustmentsRight side adjustments NeutralDampers Cutterdeck BeltTracking Handles PUMP-DRIVE Belt Belt ReplacementLimited Warranty 8495 MM & Boundary Repair Parts Rev /15/2006 Woods Equipment Company