Woods Equipment MZ2252K manual Cutterdeck Belt, Tracking Handles, Dampers

Page 38

ADJUSTMENTS

WOODS

CUTTERDECK BELT

1.Tilt floorplate all the way forward.

2.Set the cutterdeck in a middle height-of-cut posi- tion.

3.Use a 3/8" ratchet and extension to back tensioning idler off to remove belt from idler. Remove belt from cutterdeck pulleys.

NOTE: Use the 3/8" ratchet in the square hole A on the idler.

4.Remove belt from clutch pulley.

5.Install the new belt by performing these steps in reverse order.

Note: Always use Woods replacement belts, not general purpose belts. Woods belts are specially designed for use on commercial mowers and will normally last longer.

TRACKING HANDLES

An adjustment is provided to allow the operator to align the control levers with each other during opera- tion.

1.Turn knob W clockwise to shorten control lever travel.

2.Turn knob W counter-clockwise to increase con- trol lever travel.

DAMPERS

Different damper mounting holes have been provided for various operator preferences with control lever motion.

1.For a stronger resistance feel, mount the damp- ers X in the outer most hole Z of the motion control weldment.

2.For a lighter resistance feel, mount the dampers X in the inner most hole V of the motion control weldment.

38

Image 38

Contents OPERATOR’S Manual California Wash Hands After HandlingTo the Owner Important MessageTo the Dealer Alitec BMP Central Fabricators Gannon Gill WAIN-ROY WoodsTable of Contents Safety Become AlertPreparing for Safe Operation Starting Machine Operation Operating SafelyGeneral Interrupting operation Maneuvering SafelyMowing Slopes Seat Belt UseageFuel Maintenance Safety GeneralBlades Hydraulic SystemJump Starting BatteryStorage Safety Labels OFF LH Tank RH Tank Operators Manual is Located Under the Foot Plate Hydraulic OILTRANSPORT5 NN N Controls At operators right sideTurns during reverse movement Lift and traction levers operators right sideTurns during forward movement Foot Lift Pedal Compartment beneath the seat Viewed from above Pushing the MachineParking brake in on position Operators left side PRE-OPERATION Check List PRE-OPERATION Check List OWNER’S ResponsibilityBefore Starting the Engine OperationFueling Operator Presence Interlock SystemOperating Notes DrivingCutting Cutting TipsHydraulics Maintenance ChartEngine MachineMaintenance Record GeneralCheck Daily MaintenanceBattery Lubrication Periodic OIL Changes Hydraulic SystemAfter First Five 5 Hours Fuel Filter Engine OILSpark Plugs Engine Cooling Heavy Duty Cyclonic AIR CleanerTo replace air cleaner elements Cleaning Machine Washing MachineSharpening Blade InstallationBlade Removal Blade BalanceCounterbalance Springs AdjustmentsDeck Leveling Rear Deck Rollers Height of cut ranges for roller adjustmentHeight of CUT Front Deck LIPParking Brake Parking brake assembly tire and deck not shownControl Levers For clarity brake in on positionNeutral Hydrostat AdjustmentsRight side adjustments Reverse ReturnDampers Cutterdeck BeltTracking Handles Belt Replacement PUMP-DRIVE BeltLimited Warranty 8495 MM & Boundary Repair Parts Rev /15/2006 Woods Equipment Company