Woods Equipment MZ2252K Hydrostat Adjustments, Neutral, Reverse Return, Right side adjustments

Page 37

WOODS

ADJUSTMENTS

HYDROSTAT ADJUSTMENTS

A turnbuckle-style hydrostat neutral adjustment is provided.

Neutral:

1.Support the machine with the rear wheels off the ground. Use jackstands or equivalent sup- port. Do not rely only on mechanical or hydraulic jacks.

2.Move the traction levers out into the neutral lock position and raise the seat.

3.Disconnect the seat switch wire K and temporarily connect the two terminals with jumper wire J as shown.

4.Start the engine and run at low speed.

5.Loosen jam nuts T at both ends of the control rod.

6.Rotate the control rod until the corresponding wheel stops turning. Lock the jam nuts. Run the engine up to high idle to check the adjustment. Readjust if necessary.

7.Repeat steps 5 and 6 for the opposite side.

8.Remove the jumper wire J and reconnect the seat switch.

Reverse Return:

1.Move traction levers out to the neutral lock posi- tion and raise the seat.

2.Locknut U should be run on the bolt as far as it will go.

3.	Loosen jam nut Y. Adjust the clevis yoke by	Right side adjustments
	turning the head of the bolt until the clevis pin
	just makes contact with the rear of the slot in the
	lever it connects with. Tighten jam nut Y.
4.	Repeat steps 2 and 3 for the opposite side.

NOTE: A slight creep in reverse is acceptable provided the wheel does not turn and the hydrostat pump does not whine when the parking brake is on.

37

Image 37

Contents OPERATOR’S Manual Wash Hands After Handling CaliforniaTo the Dealer Important MessageTo the Owner Alitec BMP Central Fabricators Gannon Gill WAIN-ROY WoodsTable of Contents Become Alert SafetyPreparing for Safe Operation General Machine Operation Operating SafelyStarting Maneuvering Safely Interrupting operationSeat Belt Useage Mowing SlopesBlades Maintenance Safety GeneralFuel Hydraulic SystemStorage Safety BatteryJump Starting Labels OFF LH Tank RH Tank Hydraulic OIL Operators Manual is Located Under the Foot PlateTRANSPORT5 NN N At operators right side ControlsTurns during forward movement Lift and traction levers operators right sideTurns during reverse movement Foot Lift Pedal Parking brake in on position Operators left side Pushing the MachineCompartment beneath the seat Viewed from above PRE-OPERATION Check List OWNER’S Responsibility PRE-OPERATION Check ListFueling OperationBefore Starting the Engine Operator Presence Interlock SystemDriving Operating NotesCutting Tips CuttingEngine Maintenance ChartHydraulics MachineGeneral Maintenance RecordBattery MaintenanceCheck Daily Lubrication After First Five 5 Hours Hydraulic SystemPeriodic OIL Changes Spark Plugs Engine OILFuel Filter To replace air cleaner elements Heavy Duty Cyclonic AIR CleanerEngine Cooling Washing Machine Cleaning MachineBlade Removal Blade InstallationSharpening Blade BalanceDeck Leveling AdjustmentsCounterbalance Springs Height of CUT Height of cut ranges for roller adjustmentRear Deck Rollers Front Deck LIPControl Levers Parking brake assembly tire and deck not shownParking Brake For clarity brake in on positionRight side adjustments Hydrostat AdjustmentsNeutral Reverse ReturnTracking Handles Cutterdeck BeltDampers PUMP-DRIVE Belt Belt ReplacementLimited Warranty 8495 MM & Boundary Repair Parts Rev /15/2006 Woods Equipment Company