Stow manual Stow G-2.9R Controls and Indicators

Page 19

STOW G-2.9R — CONTROLS AND INDICATORS

1.

GFCI Ground – This ground connection point should be

 

connect to a good earth ground (ground rod). Applies to

 

units with S/N 5497956 and below.

2.

GFCI Receptacle – This receptacle will provide 120V at

 

all times.

3.

AC-Voltmeter – This voltmeter indicates (with a mark) the

 

rated 60 Hz, single phase output voltage. In addition the

 

voltmeter can also be used as a diagnostic tool. If the

 

voltmeter indicator (needle) is below the rated voltage,

 

engine problems may exist (low/high RPM's). To prevent

 

damage to the generator or power tools turn the generator

 

OFF and consult your authorized STOW service dealer.

4.

Main Circuit Breaker – This single-pole 22 amp breaker

 

protects the generator from short circuiting or overloading.

 

When starting the generator always have the circuit breaker

 

placed in the "OFF" position.

5.

Oil Alarm Indicator – This indicator will light in the event

 

of low oil.

This ROBIN engine is equipped with a low oil shutdown capability.A

NOTE built in sensor will automatically turn off the engine should the oil level fall below a safe operating condition. Make sure the generator is placed

on level ground. Placing the generator on level ground will ensure that the low oil sensor will function properly.

6. Operation/ON-OFF Switches – For units with S/N 5497956 and below, place rocker switch in the "RUN" position (up) for normal operation.To turn-off the generator place switch in the "STOP" position (down). For units with S/N 5497957 and above, place engine ON/OFF switch in the "ON" position for normal operation. To turn-off the generator place switch in the "OFF" position.

7. 120V Output Receptacle – This NEMA L5-20R twist- lock receptacle will provide 120V, 20 amps, 60 Hz. Applies to units with S/N 5497957 and above.

8. Generator Housing – Contains the rotor, rectifer field coil assembly, aramature, bearings and other components that make up generator asembly.

9. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.024 - 0.028 inch). Clean spark plug once a week.

10. Muffler/Heat Shield – Used to reduce noise and emissions. NEVER touch this heat shield when the generator is in use. Always allow time for the generator to cool down before performing maintenance.

WARNING

ALWAYS allow time for the generator to cool down before performing maintenance.

11. Oil Dipstick/ Filler Cap– Remove the filler cap dipstick when checking the engine oil level. Add engine oil through this filler port. See Table 4 for recommended type engine oil.

12. Oil Drain Plug – Remove this plug to drain engine oil from the crankcase.

13. Carburetor Fuel Cup – Inspect the fuel cup weekly for water and dirt. Clean as referenced in the maintenance section of this manual.

14. Choke Lever – Used for starting the engine. Close the choke lever when starting a cold engine or in cold weather conditions.The choke enriches the fuel mixture. Open the choke lever if starting a warm engine or in warm weather conditions.

15. Fuel Cock Lever – Turn this lever downward to start (down)the flow of fuel to the carburetor. Turn upward to stop (up) the flow of fuel.

16. Throttle Lever – Used to adjust engine RPM speed.This unit is set at the factory and is not adjustable.

17. Recoil Starter (Pull Rope) – Used for manual-starting of the engine. Pull the starter grip until resistance is felt, then pull briskly and smoothly.

18. Engine – This generator uses a 5.1 HP ROBIN air- cooled, 4-stroke , single cylinder, overhead camshaft gasoline engine. Engine uses unleaded fuel.

19. Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove wing-nut on top of air filter cannister to gain access to filter element. NEVER run the engine without an air cleaner.

20. Fuel Gauge – Read this gauge to determine when fuel is low.

21. Fuel Gauge/Tank – Remove this cap to add unleaded gasoline to the fuel tank. Replenish with clean unleaded gasoline. Make sure cap is tightened securely. DO NOT over fill. Fuel tank capacity is 3.17 gallons (12 liters).

22. Lifting Bail Eye – Attach a rope or chain to this lifting eye when lifting of the generator is required. Never stand underneath the generator while it is being lifted. Place lifting eye in down position when not in use. Applies to units

with S/N 5497957 and above.

STOW G-2.9R A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #1 (10/28/04) — PAGE 19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Model G-2.9R Page Heres HOW to GET Help Table of Contents When ordering parts Please supply the following information Parts Ordering ProceduresDimensions Stow G-2.9R DimensionsEffects of Altitude and Heat SpecificationsBurn Hazards Stow G-2.9R Safety Message Alert SymbolsRespiratory Hazards Rotating Parts Hazards Equipment DamageRead this manual Stow G-2.9R Rules for Safe OperationStow G-2.9R Rules for Safe Operation Emergencies Stow G-2.9R Rules for Safe OperationPage Machine Safety Decals Operation and Safety Decals S/N 5497956 and belowOperation and Safety Decals S/N 5497957 and Above Excitation System Stow G-2.9R General InformationStow G-2.9R Familarization Control PanelStow G-2.9R Load Application Single Phase LoadExtension Cables Generator Controls and Components Stow G-2.9R Controls and IndicatorsStow G-2.9R Controls and Indicators Generator Refueling Stow G-2.9R Generator RefuelingMounting Stow G-2.9R InstallationOutdoor Installation Indoor InstallationConnecting the Ground Stow G-2.9R InstallationMain Circuit Breaker General Inspection Prior to Operation Ground Power ToolsStow G-2.9R PRE-INSPECTION Extension CableFuel Check Stow G-2.9R PRE-INSPECTION EngineBefore Starting Engine Oil CheckBefore Starting the Engine Stow G-2.9R Initial START-UP EngineStow G-2.9R Initial START-UP ENGINE/OPERATION Connecting the LoadStopping The Engine Generator Storage Stow G-2.9R Preparation for Long -TERM StorageEngine Maintenance Schedule Stow G-2.9R Maintenance EngineCleaning the Fuel Strainer Stow G-2.9R Maintenance EngineMaintenance Generator/Engine Wiring Diagram S/N 5497956 and Below Stow G-2.9R Wiring Diagram S/N 5497956 and belowStow G-2.9R Wiring Diagram S/N 5497957 and Above Engine Troubleshooting Stow G-2.9R -TROUBLESHOOTING EngineStow G-2.9R -TROUBLESHOOTING Engine Generator Troubleshooting Stow G-2.9R -TROUBLESHOOTING GeneratorPage Stow G-2.9R Explanation of Code in Remarks Column How to read the marks and remarks used in this parts bookItems Found In the Items Number Column To 3 Units Stow G-2.9R Suggested Spare PartsStow G-2.9R Name Plate and Decals S/N 5497956 and below Stow G-2.9R Name Plate and Decals S/N 5497956 and below Stow G-2.9R Name Plate and Decals S/N 5497957 and Above Part Name QTY Remarks Stow G-2.9R Generator Assy SET BOLT, Rotor Stow G-2.9R Control BOX ASSY. S/N 5497956 and below Stow G-2.9R Control BOX ASSY. S/N 5497956 and below Stow G-2.9R Control BOX ASSY. S/N 5497957 and Above Stow G-2.9R Control BOX ASSY. S/N 5497957 and Above Stow G-2.9R Pipe Frame ASSY. S/N 5497956 and below Fuel GAUGE, CJ- 58A Stow G-2.9R Pipe Frame ASSY. S/N 5497956 and belowStow G-2.9R Pipe Frame ASSY. S/N 5497956 and Above A2417000302 Robin EX170D20210 Crankcase Assy Robin EX170D20210- Crankcase Assy Robin EX170D20210 Crankshaft and Piston Assy Crankshaft Assy Robin EX170D20210 Governor Assy Part Name QTY. Remarks Robin EX170D20210 Intake and Exhaust Assy PIN, CAM Shaft Robin EX170D20210 AIR Cleaner Assy Robin EX170D20210 AIR Cleaner Assy Robin EX170D20210 Cooling Starting Assy Blower Housing CP, Yellow Robin EX170D20210 -CARBURETOR Assy Robin EX170D20210 Carburetor Assy Robin EX170D20210 Flywheel Assy Part Name QTY Robin EX170D20210 Electric Device Assy OIL Sensor CP Terms and Conditions of Sale Parts Terms and Conditions of Sale Stow Construction EquipmentPage Your Local Dealer is

G-2.9R specifications

The Stow G-2.9R is an innovative and highly versatile piece of equipment designed for a variety of applications, making it a valuable asset in various industries. This unit stands out for its unique combination of power, efficiency, and user-friendly features, ensuring that it meets the demands of both professionals and casual users alike.

One of the main features of the Stow G-2.9R is its robust engine, which is designed to deliver reliable performance. With a powerful output, the engine allows users to tackle demanding tasks with ease, whether it’s in landscaping, construction, or maintenance jobs. The efficient fuel consumption of the G-2.9R not only reduces operational costs but also minimizes environmental impact, making it an eco-friendly choice for users conscious of their carbon footprint.

The Stow G-2.9R is equipped with advanced technologies that enhance its performance and usability. The integrated electronic controls provide precise management of operations, allowing users to finely tune the machine's settings according to specific requirements. This level of precision is particularly beneficial in applications such as turf management or industrial cleaning, where different surfaces and conditions may require specific adjustments.

Another noteworthy characteristic of the Stow G-2.9R is its compact design. Built for maneuverability, this machine can easily navigate tight spaces without sacrificing power or efficiency. The lightweight construction allows for easy transportation, making it suitable for different job sites. Its geometrically designed chassis ensures stability and balance during operation, enhancing safety for the user.

Furthermore, the G-2.9R also boasts ergonomic controls and comfortable handling features. The adjustable components allow users to customize their experience, which contributes to reduced fatigue during extended use. Safety features are also a priority, with mechanisms in place to protect the operator and nearby workers from potential hazards.

Durability is another key aspect of the Stow G-2.9R, as it is built with high-quality materials that withstand wear and tear in challenging working environments. The machine is designed for longevity, making it a cost-effective investment for users.

In summary, the Stow G-2.9R combines power, efficiency, advanced technology, and user-centered design to deliver exceptional performance across a wide range of applications. Its adaptable nature ensures that it meets the varying needs of users, positioning it as a reliable choice in the marketplace.
Top Page Image Contents