Shindaiwa T2510X, 82014 Product Description, Specifications, Prior to Assembly, Air cleaner type

Product Description

Using the accompanying illustrations as a guide, familiarize yourself with this unit and its various components. See Figure 4. Understanding your unit helps ensure top performance, long service life, and safer operation.

WARNING!

Do not make unauthorized modifications or alterations to any of these units or their components.

IMPORTANT!

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation.

			T2510 TRIMMER
		Throttle
		Interlock	Grip
		Ignition
	Handle	Switch
				Fuel
	Outer Tube		Throttle	Tank
			Trigger
Gear case	Cutting		T2510X TRIMMER
		Throttle
	Attachment Shield
		Interlock	Grip
		Ignition
	Hanger
		Switch
Trimmer	Handle
Head				Fuel
	Outer Tube		Throttle	Tank
			Trigger
Gear case	Barrier
	Bar
	Cutting
	Attachment Shield
Trimmer Head
Figure 4

Specifications

T2510 dry weight	......................................................11.0 lb./5.0 kg
(less attachments).
T2510X dry weight	......................................................11.3 lb./5.1 kg
(less attachments).
Engine model	SF2510E
Engine type	with Power Boost Chamber
Bore x stroke	1.3 x 1.1 in./34 x27 mm
Displacement	1.5 cu. in./ 24.5 cc
Maximum power	1.1 HP/0.8 kW
	@ 7500 rpm (min-1)
Fuel/oil ratio	50:1 with ISO-L-EGD or JASO FC
	class 2-cycle mixing oil*
Carburetor type	Walbro WYL, diaphragm-type
Fuel tank capacity	20.3 oz./600 ml
Ignition	One-piece electronic,
	program-controlled
Spark plug	NGK CMR5H

Air cleaner type	Non-reversible heavy-duty
	filter element
Starting method	Recoil
Stopping method	Slide switch
Transmission type	Automatic, centrifugal clutch
	w/bevel gear
EPA Emission	Category A
Compliance Period**.

**The EPA emission compliance referred to on the emission compliance label located on the engine, indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended).

*meets or exceeds these specifications and is

recommended for all Shindaiwa products.

Specifications are subject to change without notice.

This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

nEngine and shaft assembly

nCutting attachment shield

nCutting attachment

nKit containing cutting attachment shield mounting bracket and hardware, this owner’s/operator’s manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench set, a spark plug/screwdriver combination wrench, and a spanner.