Shindaiwa 82050, EB633RT manual Manufacturers Warranty Coverage, Owners Warranty Responsibilities

Page 23

Shindaiwa Corporation

EPA PHASE 2 / CALIFORNIA TIER III EMISSION

CONTROL WARRANTY STATEMENT - WARRANTY RIGHTS AND OBLIGATIONS

English

The Environmental Protection Agency (EPA) and the California Air Resources Board (C.A.R.B.) and Shindaiwa Inc. are pleased to explain the emission control system warranty on your EPA Phase 2 / C.A.R.B. Tier III model year 2007 and later small off road engine (SORE). New small off road engines must be designed, built and equipped to meet stringent EPA and C.A.R.B. anti-smog standards. Shindaiwa Inc. warrants the emission control system on your small off road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off road engine.

Your emission control system may include parts such as: carburetor/fuel injected system, ignition system, catalytic converter, fuel tank, fuel lines, fuel caps, valves, canisters, filters vapor hoses, clamps connectors, and other associated components. For certain hand-held products with engines less than or equal to 80cc displacement, the fuel tank is subject to the C.A.R.B. evaporative emission control warranty requirements of this sec- tion. Contact Shindaiwa Inc. for the models covered under the C.A.R.B. evaporative emission regulations.

Where a warrantable condition exists, Shindaiwa Inc. or its authorized service representative will repair your small off road engine at no cost to you including diagnosis, parts and labor.

MANUFACTURER'S WARRANTY COVERAGE:

The 2007 and later small off road engines are warranted for two years for certain emission related parts. If any emission-related part on your engine is defective, the part will be repaired or replaced by Shindaiwa Inc. or its authorized service representative.

OWNER'S WARRANTY RESPONSIBILITIES:

As the small off road engine owner, you are responsible for the per- formance of the required maintenance listed in your Operator's Manual. Shindaiwa Inc. recommends that you retain all receipts covering main- tenance on your small off road engine, but Shindaiwa Inc. cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off road engine owner, you should however be aware that Shindaiwa Inc. may deny you warranty coverage if your small off road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off road engine to Shindaiwa Inc.’s authorized service center as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you can contact Shindaiwa Inc. at 800-521-7733 or www.shindaiwa.com

EPA PHASE 2 / CALIFORNIA TIER III EMISSIONS DEFECT WARRANTY EXPLANATION

This is additional detailed information about the EPA PHASE 2/ CALIFORNIA TIER III EMISSIONS DEFECT WARRANTY for your small off road engine.

HOW WILL A COVERED PART BE CORRECTED?

If there is a defect in a part covered by this warranty, Shindaiwa Inc.’s authorized service dealer will correct the defect.

You will not have to pay anything to have the part adjusted, repaired or replaced. This includes any labor and diagnosis for warranted repairs performed by the dealer. In addition, engine parts not expressly covered under this warranty but whose failure is a result of a failure of a covered part will be warranted.

Emissions System repairs covered under this warranty should be complet- ed in a reasonable time, not to exceed 30 days.

IMPORTANT

If the diagnosis reveals no defect, the emission defect warranty does not apply.

WHAT PARTS ARE COVERED BY THE EPA PHASE 2/ CALIFORNIA TIER III 2007 & LATER SMALL OFF ROAD ENGINE EMISSIONS DEFECT WARRANTY?

Any emission related part not scheduled for, "required maintenance" (See Operator’s Manual, "SERVICE MAINTENANCE SCHEDULE") will be repaired or replaced within the warranty period. The repaired or re- placed part will be warranted for the remaining Emissions Defect warranty period.

Any emission related part scheduled for replacement during "required maintenance" (See Operator’s Manual, "SERVICE MAINTENANCE

SCHEDULE") is warranted for the period of time prior to the first sched- uled replacement point for that part. Any such part repaired or replaced under warranty shall be warranted for the remainder of the period prior to the first scheduled replacement point for that part.

Any Shindaiwa Inc. approved replacement part may be used in the performance of any warranty maintenance or repairs on emission-related parts, and must be provided without charge if the part is still under war- ranty.

Any replacement part that is equivalent in performance and durability may be used in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of Shindaiwa Inc.

The owner is responsible for the performance of the required mainte- nance described in the operator’s manual.

SPECIFIC EMISSION RELATED WARRANTED PARTS:

Choke

Carburetor (complete assembly or replaceable components) Fuel Injection Assembly or replaceable components

Air Filter

Electronic Ignition System Spark Plug

Catalytic Converter / Muffler Assembly

Fuel Tank (CARB only)

WHAT DOES THIS WARRANTY COVER?

Shindaiwa Inc. warrants that your unit was designed, built and equipped to conform with applicable EPA and California emissions standards and that your unit is free from defects in material and workmanship that would cause it to fail to conform with applicable requirements within two (2) years. The warranty period begins on the date the product is delivered

to a retail purchaser. This is your emission control system DEFECTS WARRANTY.

WHAT IS NOT COVERED BY THE EPA PHASE 2/ CALIFORNIA TIER III 2007 & LATER SMALL OFF ROAD ENGINE EMISSIONS DEFECT WARRANTY?

Any failure caused by abuse, neglect, improper maintenance.

Any failure caused by unapproved modifications, use of unap-

proved add-on parts/modified parts or unapproved accessories.

23

Image 23
Contents EB633RT Blower Operators manual Table of ContentsIntroduction Personal condition and safety equipment Safety Manual safety symbols and important informationInternational symbols Breathing Protection Physical ConditionEye Protection Hand ProtectionKeep a Firm Grip Repetitive Stress InjuriesRead the Manuals Clear the Work AreaProduct Emission Durability EPA Phase 2/ C.A.R.B. TierEquipment Check Emission ControlDescription Located on blower housingHot Decal near muffler Contents Install blower pipes AssemblyOperation Fuel Fuel RequirementsHandling Fuel Metric Starting cold engineStopping engine Starting warm engineOperating blower Skill level MaintenanceMaintenance intervals Level Air filterSpark plug Fuel filterCooling system Cleaning Cylinder FinsExhaust system Spark Arrestor ScreenCylinder Exhaust Port Engine Break-In High Altitude AdjustmentCarburetor adjustment Troubleshooting Chart TroubleshootingStorage Long Term Storage Over 30 DaysEB633RT SpecificationsHOW will a Covered Part be CORRECTED? Manufacturers Warranty CoverageOwners Warranty Responsibilities What does this Warranty COVER?English Sopladora EB633RT Tabla de materias IntroducciónManual del operador Condición personal y equipos de seguridad Símbolos internacionalesProtección respiratoria Condición físicaProtección de los ojos Protección de las manosPeligro Lesiones debidas a esfuerzos repetitivosControl de emisiones Fase 2 de EPA / Nivel III de C.A.R.BEquipos Descripción Calcomanías de caliente cerca del silenciadorCalcomania de ruido Ubicada en la cubierta del sopladorContenido Nota EnsamblarInstale los tubos del soplador Combustible Requisitos del combustibleManipulación del combustible OperaciónArranque de un motor en frío Combustible, continuaciónParada del motor Arranque del motor calienteOperación del soplador ¡IMPORTANTE MantenimientoNivel de habilidad Intervalos de mantenimientoAviso Filtro de aireBujía Filtro de combustibleLimpieza de la parrilla Sistemas de enfriamientoOrificio de escape del cilindro Rejilla del apagachispasAjuste del carburador Rodaje del motorAjuste de altitud elevada Localización y reparación de fallas Almacenamiento a largo plazo más de 30 días AlmacenamientoEspecificaciones Pequeños Motores DE Exteriores Relacionados CON LAS Emisiones EPA PhaseCalifornia Tier III Emissions Defect Warranty EN Relacionados CON Emisiones EPA Phase 2 / CaliforniaNotas EB633RT Soufflante Table des matières Le manuel d’utilisationAvertissement Sécurité Symboles de sécurité et informations importantesProtection des voies respiratoires Condition physiqueProtection des yeux Protection des mainsLisez les manuels Microtraumatismes répétésDurabilité DU Contrôle DES Émissions Vérifiez l’équipementContrôle des émissions Sur le corps de la soufflante CategoryContenu Remarque Installation des tubes de soufflanteAssemblage Carburant Spécifications pour le carburantManipulation du carburant UtilisationDémarrage d’un moteur froid Carburant, continuéArrêt du moteur Démarrage d’un moteur chaudFR13 Intervalles d’entretien EntretienNiveaux de difficulte Avis Filtre à airBougie Filtre à carburantNettoyage de la grille Système de refroidissementSystème d’échappement Pare-étincellesLumière d’échappement du cylindre Réglage du carburateur Rodage du moteurRéglage pour haute altitude Dépannage Remisage Remisage à long terme plus de 30 joursCaractéristiques EN CAS DE Pièce Défectueuse Couverture DE LA Garantie DES FabricantsResponsabilités DU Propriétaire À L’ÉGARD DE LA Garantie CE QUE Couvre Cette Garantie

82050, EB633RT specifications

The Shindaiwa EB633RT is a top-of-the-line backpack blower designed for professional landscaping and heavy-duty yard work. Known for its power, efficiency, and user-friendly features, the EB633RT stands out in the competitive market of outdoor power equipment.

At the heart of the EB633RT is a reliable 63.3cc two-stroke engine, which produces a remarkable air velocity of up to 210 mph and an air volume of 510 CFM. This combination of power and airflow makes it highly effective for cleaning up leaves, debris, and even small branches, making it an ideal tool for both residential users and commercial landscapers.

The EB633RT incorporates Shindaiwa's unique "Electronic Fuel Injection" (EFI) technology. This innovative feature enhances fuel efficiency, reduces emissions, and improves cold starting performance. As a result, users can enjoy longer run times with fewer trips to refill the tank, leading to increased productivity and reduced environmental impact.

Another standout characteristic of the Shindaiwa EB633RT is its ergonomic design. The backpack is equipped with a padded, adjustable harness that provides comfort during extended use. This feature allows for optimal weight distribution, minimizing strain on the user’s back and shoulders. The blower also has a flexible tube design, which aids in maneuverability, allowing users to reach tight spaces with ease.

The EB633RT also comes with a user-friendly starting system, ensuring that the blower can be easily started even after prolonged periods of storage. With its easy-access air filter and spark plug, routine maintenance is made simple, allowing users to keep their equipment in optimal condition.

Durability is another strong point of the EB633RT. Constructed from robust materials, this blower is built to withstand the rigors of commercial use, ensuring longevity and reliability in various working conditions.

Overall, the Shindaiwa EB633RT is an exceptional choice for professionals seeking a powerful, efficient, and comfortable backpack blower. Its advanced technologies, high performance, and ergonomic design place it among the best in its class, making it a trusted companion for tackling the toughest landscaping challenges. Whether you are a professional landscaper or a dedicated homeowner, the EB633RT is equipped to handle your outdoor tasks with ease.