Setup
7.To exit from the Setup Preamp Mode press the SETUP
4.If no other adjustments are to be made at this time, press the SETUP
Default Settings
The following listings indicate the Setup Menu Mode (Con- troller or Preamp), Menu Name, Default Setting and the page number for instructions on how to change a setting.
Menu | Function Name | Setting | Page No. |
Control | Version (C500 Firmware) | _ . _ _ | 17 |
Control | Display (Brightness) | 7 | 17 |
Control | Remote (Control) | HR061 | 17 |
Control | Meter (Illumination) | ON | 18 |
Control | Volume (Display) | Percent | 18 |
Control | Trigger A Lvl (Rear Panel Jack) | 5V | 18 |
Control | Trigger B Lvl (Rear Panel Jack) | 5V | 19 |
Control | Triamp (Balanced Outputs) | OFF | 18 |
Control | D/A Ctrl (MDA1000) | OFF | 19 |
Preamp | Input 3 (Title of Inputs) | TUN | 20 |
Preamp | D Port (Assignment to Input) | Note 2 | 20 |
Preamp | Trim (Input Source Level) | 0.0 | 21 |
Preamp | Trigger (Input Source) | 22 | |
Preamp | ACC Control (Remote Con.) | 22 | |
Preamp | LPROC (Listen Processor) | NONE | 23 |
Preamp | RPROC (Record Processor) | NONE | 23 |
Preamp | MM (Phono Capacitance) | 50PF | 24 |
Preamp | MC (Phono Resistance) | 25 OHM | 24 |
Preamp | Passthru (Multichannel) | OFF | 24 |
Notes: 1. Charts on page 25 allow for recording any changes made to the default settings.
2.The D. Port default assignment is the same as the C500 Controller Rear Panel Data Port Labeling.
Firmware Version
The C500 functionality is controlled by internal software that is know as Firmware. The Version of the Firmware in the C500 can be identified at any time by utilizing the Setup Controller Mode.
1.Press the SETUP
2.Rotate the MENU Control until VERSION 1.0 or higher appears. Refer to figure 7.
Display Brightness
The Front Panel Alphanumeric DISPLAY Brightness may be varied from a setting of 1 (Dim) to 7 (Bright). Follow the steps below for reducing the Display Brightness.
1.Press the SETUP
2.Rotate the MENU Control until the word “DISPLAY 7” appears. Refer to figure 8.
Figure 8
3.Rotate the SELECT 2 Control until the Front Panel Al- phanumeric Display indicates “DISPLAY 5” or the de- sired Brightness is achived. Refer to figure 9.
Figure 9
4.If no other adjustments are to be made at this time, press the SETUP
Remote Control
The C500 Preamplifier default setting for remote control operation is for the supplied McIntosh HR061 Remote Con- trol. The setting may be changed to allow the C500 to work with the legacy HR054 Remote Control by performing the following steps:
1.Press the SETUP
2.Rotate the MENU Control until the words “REMOTE HR061” appears. Refer to figure 9A.
Figure 9A
Figure 7
3.The number after the character V is the Firmware num- ber.
17