Neuton CE 6.2 manual Cleaning the Trimmer, Attaching and Using the Striper Roller

Cleaning the Trimmer

Periodically clean the Trimmer to ensure peak performance.

Supplies Needed:

•Clean, damp cloth or sponge

•Mild soap or detergent (if needed)

•Soft nylon brush (if needed)

1.Remove the Safety Key and remove the Trimmer from the Mower.

2.Using a damp cloth or sponge with a mild soap or detergent, clean the Trimmer. Never use water, gasoline, solvents, or other petroleum-based or solvent-based products when cleaning – remember that this is an electric Trimmer.

3.Use a soft nylon brush or non-metallic scrubbing pad to remove any clippings that have accumulated on the Trimmer and underside of the Trimmer Shield. Do not use a wire brush; it will scratch and harm the surface of your Trimmer.

4.Remove any grass or weeds that might have wound around the Spool.

5.Store the Trimmer indoors in a dry place and out of the reach of children.

Attaching and Using the Striper Roller

ALWAYS REMOVE THE SAFETY KEY BEFORE ATTACHING OR REMOVING THE STRIPER ROLLER.

The Striper Roller (Figure 41) easily attaches with Hooks into pre-formed Slots (one each side) at the rear of the NEUTON Mower (Figure 42). You can use either the Bagger attachment (recommended) or the Mulching Plug (but not the Side Discharge Chute) with the Striper Roller.

Hooks Hook

Slot

Figure 41 Figure 42

50 1-866-NEUTON1 (638-8661) www.neutonpower.com