Meridian America 504 manual Selecting a station, To switch on from standby, To switch to standby

Page 13

Selecting a station

During normal use the FM tuner should be left in the standby state. This uses a negligible amount of electricity, but ensures that the components of the FM tuner operate at maximum efficiency from the moment you start listening to a station.

If you are not going to use the FM tuner for a period of several days you should switch the unit completely off, at the back panel, and disconnect it from the AC power supply.

To switch on from standby

Press [ (Previous) or ] (Next).

Switch on any other equipment connected to the FM tuner which is not part of the Meridian 500 Series.

Keeping either key held down will step through the preset stations in turn.

Note that before using the FM tuner for the first time you may need to set the preset frequencies for your area; see To programme a preset, page 13.

To switch to standby

Press Off.

.

The display will show:

If you have other Meridian 500 Series equipment connected to the FM tuner, these units will also switch to standby.

To select a preset station

Press [ (Previous) or ] (Next) until the display shows the station you want to listen to, or type the number of the preset (remote only).

Using the FM

For example, for Radio 3

the display will show:

Radio 3

tuner

9

Image 13
Contents Meridian 504 Stereo FM Tuner Preface Contents Preface Introduction Meridian 500 Series Professional featuresSeries communications 506 20-Bit CD Player Compact Disc Transport Sample configurations566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Specification Specification and accessoriesAvailable accessories Using the FM tuner Front panel To switch to standby To switch on from standbyTo select a preset station Selecting a stationTo search for a station Tuning manuallyTo switch to mono To switch to stereoSelecting stereo or mono Defining preset stations To choose the station at switch-on To programme a presetChoosing the display To use the tuning meterTo change the display To set up the FM tuner options Setting up the FM tunerTo alter a preset label To set up the preset labelsSetting up the FM tuner Radio interference UnpackingTo position the FM tuner Back panel Connecting the FM tunerTo connect an antenna To connect to other Meridian 500 Series equipment To connect to a conventional preamplifierTo connect to Meridian 600 or 200 Series equipment To connect to a 501 Control Unit There is a hum using the analogue output TroubleshootingNo standby display is shown Reception is poorSetting up the FM tuner Cleaning MaintenanceTo clean the case, display panel, and keypad To clean the audio connectionsService Service and guaranteeGuarantee Index IndexStations