Meridian America 504 Tuning manually, To search for a station

Page 14

Tuning manually

You use manual tuning to programme the preset stations, or to select stations that you have not assigned to one of the presets.

To search for a station

The 504 Stereo FM Tuner is initially set up to use seek tuning. In this mode it automatically searches for stations, and stops when it finds one.

Press A (Up) to seek upwards in frequency, or V (Down) to seek downwards in frequency.

The FM tuner will switch to the frequency display, and then search in the direction you have specified until a station is found.

You can also select step tuning. In this mode you can step through the frequencies in steps of 0.05MHz. To set step tuning see To set up the FM tuner options, page 15.

You can adjust the criterion for adequate signal strength using the Setup Stop Strength option; see To set up the FM tuner options, page 15.

Using the FM tuner

The display will show the

station frequency.

93.O

10

Image 14
Contents Meridian 504 Stereo FM Tuner Preface Contents Preface Introduction Series communications Professional featuresMeridian 500 Series Sample configurations 506 20-Bit CD Player Compact Disc Transport566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Available accessories Specification and accessoriesSpecification Using the FM tuner Front panel To select a preset station To switch on from standbyTo switch to standby Selecting a stationTuning manually To search for a stationSelecting stereo or mono To switch to stereoTo switch to mono Defining preset stations To programme a preset To choose the station at switch-onTo change the display To use the tuning meterChoosing the display Setting up the FM tuner To set up the FM tuner optionsTo set up the preset labels To alter a preset labelSetting up the FM tuner To position the FM tuner UnpackingRadio interference To connect an antenna Connecting the FM tunerBack panel To connect to a conventional preamplifier To connect to other Meridian 500 Series equipmentTo connect to Meridian 600 or 200 Series equipment To connect to a 501 Control Unit No standby display is shown TroubleshootingThere is a hum using the analogue output Reception is poorSetting up the FM tuner To clean the case, display panel, and keypad MaintenanceCleaning To clean the audio connectionsGuarantee Service and guaranteeService Index IndexStations