Meridian America 504 manual To connect to Meridian 600 or 200 Series equipment

Page 25

This is the unit that will respond to the remote.

All the other units will be configured

To connect to Meridian 600 or 200 Series equipment

as non-controllers, and display:

N.Con.

If your system includes any Meridian 600 or 200 Series units, with 600 COMMS or 200 COMMS sockets, you should set all

Your system is now set up and ready for use.

If for any reason the automatic setup does not give the configuration you want, restore the default operation by selecting Type 1 as described in To connect to Meridian 600 or 200 Series equipment, opposite.

If you want to change the automatic setup configuration refer to the Meridian 500 Series User Guide.

Note: Do not, under any circumstances, connect any equipment other than Meridian 500, 600, or 200 Series to the socket marked COMMS on the back of the FM tuner.

the 500 Series units to 200 COMMS operation using the following procedure:

Turn off the FM tuner, using the power switch on the back panel.

Turn on the power again while holding down the Off key on the front panel.

The display will show the current

Type

1

setup:

 

 

Press ] (Next) on the front panel

 

 

Type

2

to change to Type 2:

 

 

Switch the power off and on again to restore the FM tuner to normal operation.

To return to 500 COMMS operation repeat the above procedure, and select Type 1.

Setting up the FM tuner

21

Image 25
Contents Meridian 504 Stereo FM Tuner Preface Contents Preface Introduction Meridian 500 Series Professional featuresSeries communications 506 20-Bit CD Player Compact Disc Transport Sample configurations566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Specification Specification and accessoriesAvailable accessories Using the FM tuner Front panel To switch to standby To switch on from standbyTo select a preset station Selecting a stationTo search for a station Tuning manuallyTo switch to mono To switch to stereoSelecting stereo or mono Defining preset stations To choose the station at switch-on To programme a presetChoosing the display To use the tuning meterTo change the display To set up the FM tuner options Setting up the FM tunerTo alter a preset label To set up the preset labelsSetting up the FM tuner Radio interference UnpackingTo position the FM tuner Back panel Connecting the FM tunerTo connect an antenna To connect to other Meridian 500 Series equipment To connect to a conventional preamplifierTo connect to Meridian 600 or 200 Series equipment To connect to a 501 Control Unit There is a hum using the analogue output TroubleshootingNo standby display is shown Reception is poorSetting up the FM tuner Cleaning MaintenanceTo clean the case, display panel, and keypad To clean the audio connectionsService Service and guaranteeGuarantee Index IndexStations