Meridian America 504 manual To set up the preset labels, To alter a preset label

Page 20

To set up the preset labels

●Turn off the FM tuner, using the power switch on the back panel.

●Turn on the power again while holding down the Store key on the front panel.

If there was previously no label the display will be blank.

A flashing block cursor shows which character you can change.

●Press A (Up) or V (Down) to change the character.

The display will show:

It will then show the first preset number…

Labels

1

The character cycles through the symbols: 0 – 9, a – z, A – Z, ., and space.

●Press Store to move on to the next character.

●When you have specified all eight characters press Store to store the label.

…followed by the corresponding preset label:

¥adio 1

The display will show:

Stored

the FM tuner

To alter a preset label

●Press ] (Next) or [ (Previous) to select the number of the preset you want to alter.

●When you have finished defining labels, switch the power off and on again to restore the FM tuner to normal operation.

Using

After a short delay the existing

label is shown:

¥adio 3

16

Image 20

Contents Meridian 504 Stereo FM Tuner Preface Contents Preface Introduction Series communications Professional featuresMeridian 500 Series Sample configurations 506 20-Bit CD Player Compact Disc Transport566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Available accessories Specification and accessoriesSpecification Using the FM tuner Front panel To switch on from standby To switch to standbyTo select a preset station Selecting a stationTuning manually To search for a stationSelecting stereo or mono To switch to stereoTo switch to mono Defining preset stations To programme a preset To choose the station at switch-onTo change the display To use the tuning meterChoosing the display Setting up the FM tuner To set up the FM tuner optionsTo set up the preset labels To alter a preset labelSetting up the FM tuner To position the FM tuner UnpackingRadio interference To connect an antenna Connecting the FM tunerBack panel To connect to a conventional preamplifier To connect to other Meridian 500 Series equipmentTo connect to Meridian 600 or 200 Series equipment To connect to a 501 Control Unit Troubleshooting There is a hum using the analogue outputNo standby display is shown Reception is poorSetting up the FM tuner Maintenance CleaningTo clean the case, display panel, and keypad To clean the audio connectionsGuarantee Service and guaranteeService Index IndexStations