Multiquip operation manual DCA-600SSK Generator OUTPUTS/GAUGE Reading, Maximum Amps

DCA-600SSK — GENERATOR OUTPUTS/GAUGE READING

Maximum Amps

Table 10 shows the maximum amps the generator can pro- vide. DO NOT exceed the maximum amps as listed.

Table 10. Generator Maximum Amps

Model	DCA600SSK
Rated Voltage	Maximum Amps
Single Phase	1,333.3 amps (4 wire)
120 Volt
Single Phase	666.7 amps (4 wire)
240 Volt
Three Phase	1.443 amps
240 Volt
Three Phase	721.7 amps
480 Volt

Figure 17. AC Voltmeter	Figure 18 AC Voltmeter
Change-Over Switch	Gauge
	(Volt reading on W-U Lug)

How to Read the Output Terminal Gauge.

The AC ammeter and AC voltmeter change-over switches on the control panel DO NOT effect the generator output. They are provided to help observe how much power is being supplied, produced at the UVWO terminals lugs.

When the voltage change-over board is jumpered for 3Ø, 240V operation (See Figure 16), place the AC Voltmeter Change-Over Switch (Figure 17) to the W-U position and the AC Ammeter Change-Over Switch (Figure 19) to the U or W position to read the output on the selected leg.

Figure 19. AC Ammeter

Change-Over Switch

40

2060

0 75

A

Figure 20. AC Ammeter (Amp reading on U lug)

NOTE	The ammeter and voltmeter
	gauges are only active when the
	UVWO terminals are in use.

Figure 16. Voltage Change-Over Board

240V Configuration

DCA-600SSK — OPERATION AND PARTS MANUAL (STD)— REV. #7 (04/30/10) — PAGE 37