Monessen Hearth dst30 operating instructions Model DST30, Read and Save These Instructions

Page 1

UNVENTED GAS LOG HEATER OR VENTED DECORATIVE APPLIANCE

INSTALLATION AND OPERATING INSTRUCTIONS

MODEL: DST30

Natural Gas or Propane/LPG • Control Type: Milli-Volt

This is an unvented gas-ﬁred heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Refer to page 7.

WARNINGS

If the information in this manual is not followed exactly, a ﬁre or explosion may result causing property damage, personal injury or loss of life.

–Do not store or use gasoline or other ﬂammable vapors and liquids in the vicinity of this or any other appliance.

–WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

•If you cannot reach your gas supplier, call the ﬁre department.

–Installation and service must be performed by a qualified installer, service agency or the gas supplier.

READ AND SAVE THESE INSTRUCTIONS

Image 1

Contents Read and Save These Instructions Model DST30What to do if YOU Smell GAS Contents Installer Important Safety InformationOwner For Massachusetts Residents only Getting Started What YOU will Need for InstallationMake Sure YOU have Received ALL Parts Natural GAS Product Features and SpecificationsPROPANE/LPG Codes General Installation InformationAdequate Combustion and Ventilation AIR BTU/Hr = 15 1/ 2 + 12 x 12 x 1000 = 52800 BTU/Hr Fireplace and Hearth Dimensions Height of Restriction Minimum Depth of Fireplace/Firebox Placement in a Fireplace with a Restrictive BarrierSidewall and Ceiling Clearances Clearances and Height RequirementsClearances and Height Requirements Measuring Heat Resistant Material for Mantel Maximum of 10 at a minimum of 28 above the ﬁrebox Clearances and Height RequirmentsMinimum Clearance above Combustible Flooring Floor ClearanceBefore Fully Installing the Unit Installing Vented ApplicationsBefore Installing the Appliance Damper Stop InstallationAssembly Procedure Installing Vented ApplicationsPlacing and Securing Appliance Gas Connection Connecting the GASMILLI-VOLT Control Figure Checking GAS PressureConnecting Optional Wall Switch or Thermostat Electrical Wiring MILLI-VOLTOperate Checking System Operation Connecting Remote ReceiverComplete Millivolt System Check Placing the Decorative Rock LOG PlacementChecking the Pilot Flame Flame AppearanceMILLI-VOLT Control Operating Instructions Checking the Burner FlameOperating Instructions For Your Safety Read Before LightingWhat to do if YOU Smell GAS To Turn OFF GAS to Heater MILLI-VOLT Control Lighting InstructionsCleaning and Servicing Operating Instructions and Cleaning and ServicingMatch Lighting Instructions Observed Problem Possible Cause Remedy TroubleshootingBurner does not light after ODS Illustrated Parts Breakdown Replacement Parts are Available Through Your Retailer Replacement Parts ListFive Year Warranty Lifetime WarrantyBasic Warranty