Monessen Hearth dst30 Getting Started, Make Sure YOU have Received ALL Parts

Page 5

GETTING STARTED

MAKE SURE YOU HAVE RECEIVED ALL PARTS:

Check your packing list to verify that all listed parts have been received. You should have the following:

• Unvented gas log grate/burner assembly

• Plastic bag containing crushed volcanic rock

•

Installation/operating instructions

•

Four (4) anchoring screws

•

Ceramic Fiber logs

•

Four (4) self-tapping screws

The milli-volt controlled version of this heater is the only style designed to be operated with optional devices for ON/OFF functions. The following options may be used with the millivolt controlled heater. These options are not packaged with the log set.

•

Hand held Remote with receiver

•

Wall thermostat with 15' wire

•

Wall switch with 15' wire

•

Hand held Thermostat Remote with receiver

CAUTION

•Handle the gas log burner assembly by the grate only. Do not pick the unit up by the burners.

•Gloves are recommended when handling ceramic fiber logs to prevent skin irritation from loose fibers. Logs are fragile — handle with care.

Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you

have all parts in good condition.

WHAT YOU WILL NEED FOR INSTALLATION:

You must have the following items available before proceeding with installation:

• External regulator (for propane/LPG and 1/2 lb. or greater, natural gas systems)

•

Piping which complies with local codes

•

Sediment trap

•

Screwdriver

•

Tee joint.

• Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)

• Drill with 5/32 bit

• Pipe wrench or appropriate size crescent wrench set

• Manual shutoff valve

43D0122

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents What to do if YOU Smell GAS Model DST30Read and Save These Instructions Contents Owner Important Safety InformationInstaller For Massachusetts Residents only Make Sure YOU have Received ALL Parts What YOU will Need for InstallationGetting Started PROPANE/LPG Product Features and SpecificationsNatural GAS Adequate Combustion and Ventilation AIR General Installation InformationCodes BTU/Hr = 15 1/ 2 + 12 x 12 x 1000 = 52800 BTU/Hr Fireplace and Hearth Dimensions Height of Restriction Minimum Depth of Fireplace/Firebox Placement in a Fireplace with a Restrictive BarrierSidewall and Ceiling Clearances Clearances and Height RequirementsClearances and Height Requirements Measuring Heat Resistant Material for Mantel Maximum of 10 at a minimum of 28 above the firebox Clearances and Height RequirmentsMinimum Clearance above Combustible Flooring Floor ClearanceBefore Fully Installing the Unit Installing Vented ApplicationsBefore Installing the Appliance Damper Stop InstallationPlacing and Securing Appliance Installing Vented ApplicationsAssembly Procedure Gas Connection Connecting the GASMILLI-VOLT Control Figure Checking GAS PressureOperate Electrical Wiring MILLI-VOLTConnecting Optional Wall Switch or Thermostat Complete Millivolt System Check Connecting Remote ReceiverChecking System Operation Placing the Decorative Rock LOG PlacementMILLI-VOLT Control Flame AppearanceChecking the Pilot Flame Operating Instructions Checking the Burner FlameWhat to do if YOU Smell GAS For Your Safety Read Before LightingOperating Instructions To Turn OFF GAS to Heater MILLI-VOLT Control Lighting InstructionsMatch Lighting Instructions Operating Instructions and Cleaning and ServicingCleaning and Servicing Observed Problem Possible Cause Remedy TroubleshootingBurner does not light after ODS Illustrated Parts Breakdown Replacement Parts are Available Through Your Retailer Replacement Parts ListBasic Warranty Lifetime WarrantyFive Year Warranty
Top Page Image Contents