Monessen Hearth dst30 Operating Instructions, For Your Safety Read Before Lighting

Page 25

OPERATING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING

If you do not follow these instruction exactly, a ﬁre or explosion may result causing property damage, personal injury or loss of life.

A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the unit by hand.

B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the ﬂoor because some gas is heavier than air and will settle on the ﬂoor.

WHAT TO DO IF YOU SMELL GAS:

•Do not attempt to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

•If you cannot reach your gas supplier, call the ﬁre department.

C.Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it. Call a qualiﬁed service technician. Force or attempted repair may result in a ﬁre or explosion.

D.Do not use this appliance if any part of it has been under water. Immediately call a qualiﬁed service technician to inspect the appliance and to replace any part of the control system and any gas control that has been under water.

Control Knobs

Piezo

Ignitor

Switch

Figure 21 - Location of Piezo Ignitor, Control Knobs and Switch on Milli-Volt Unit

43D0122

25

Image 25

Contents Read and Save These Instructions Model DST30What to do if YOU Smell GAS Contents Installer Important Safety InformationOwner For Massachusetts Residents only Getting Started What YOU will Need for InstallationMake Sure YOU have Received ALL Parts Natural GAS Product Features and SpecificationsPROPANE/LPG Codes General Installation InformationAdequate Combustion and Ventilation AIR BTU/Hr = 15 1/ 2 + 12 x 12 x 1000 = 52800 BTU/Hr Fireplace and Hearth Dimensions Height of Restriction Minimum Depth of Fireplace/Firebox Placement in a Fireplace with a Restrictive BarrierSidewall and Ceiling Clearances Clearances and Height RequirementsClearances and Height Requirements Measuring Heat Resistant Material for Mantel Maximum of 10 at a minimum of 28 above the ﬁrebox Clearances and Height RequirmentsMinimum Clearance above Combustible Flooring Floor ClearanceBefore Fully Installing the Unit Installing Vented ApplicationsBefore Installing the Appliance Damper Stop InstallationAssembly Procedure Installing Vented ApplicationsPlacing and Securing Appliance Gas Connection Connecting the GASMILLI-VOLT Control Figure Checking GAS PressureConnecting Optional Wall Switch or Thermostat Electrical Wiring MILLI-VOLTOperate Checking System Operation Connecting Remote ReceiverComplete Millivolt System Check Placing the Decorative Rock LOG PlacementChecking the Pilot Flame Flame AppearanceMILLI-VOLT Control Operating Instructions Checking the Burner FlameOperating Instructions For Your Safety Read Before LightingWhat to do if YOU Smell GAS To Turn OFF GAS to Heater MILLI-VOLT Control Lighting InstructionsCleaning and Servicing Operating Instructions and Cleaning and ServicingMatch Lighting Instructions Observed Problem Possible Cause Remedy TroubleshootingBurner does not light after ODS Illustrated Parts Breakdown Replacement Parts are Available Through Your Retailer Replacement Parts ListFive Year Warranty Lifetime WarrantyBasic Warranty