Monessen Hearth dst30 operating instructions Checking the Burner Flame, Operating Instructions

Page 24

CHECKING THE BURNER FLAME

In normal operation at full rate after 15 minutes, the following ﬂame appearances should be observed:

Figure 20 - Correct Appearance of Flames

The flames should be yellow and extend 3"-4" above the log top surfaces. The yellow flames should not contact the logs.

OPERATING INSTRUCTIONS

Avoid any drafts that alter burner ﬂame patterns. Do not allow fans to blow directly into the ﬁreplace. Do not place a blower inside the burn area of the ﬁrebox. Ceiling fans may create drafts that alter ﬂame patterns. Sooting and improper burning will result.

During manufacturing, fabricating and shipping, various components of this appliance are treated with certain oils, ﬁlms or bonding agents. These chemicals are not harmful, but may produce annoying smoke and smells as they are burned off during the initial operation of the appliance, possibly causing headaches or eye or lung irritation. This is a normal and temporary occurrence.

The initial break-in operation should last two to three hours with the burner at the highest setting. Provide maximum ventilation by opening windows or doors to allow odors to dissipate. Any odors remaining after this initial break-in will be slight and will disappear with continued use.This appliance must not be used with glass doors in the closed position. This can lead to pilot outages and severe sooting outside the ﬁreplace.

24

43D0122

Image 24

Contents Model DST30 Read and Save These InstructionsWhat to do if YOU Smell GAS Contents Important Safety Information InstallerOwner For Massachusetts Residents only What YOU will Need for Installation Getting StartedMake Sure YOU have Received ALL Parts Product Features and Specifications Natural GASPROPANE/LPG General Installation Information CodesAdequate Combustion and Ventilation AIR BTU/Hr = 15 1/ 2 + 12 x 12 x 1000 = 52800 BTU/Hr Fireplace and Hearth Dimensions Placement in a Fireplace with a Restrictive Barrier Height of Restriction Minimum Depth of Fireplace/FireboxClearances and Height Requirements Sidewall and Ceiling ClearancesClearances and Height Requirements Measuring Heat Resistant Material for Mantel Clearances and Height Requirments Maximum of 10 at a minimum of 28 above the ﬁreboxFloor Clearance Minimum Clearance above Combustible FlooringInstalling Vented Applications Before Fully Installing the UnitBefore Installing the Appliance Damper Stop InstallationInstalling Vented Applications Assembly ProcedurePlacing and Securing Appliance Connecting the GAS Gas ConnectionChecking GAS Pressure MILLI-VOLT Control FigureElectrical Wiring MILLI-VOLT Connecting Optional Wall Switch or ThermostatOperate Connecting Remote Receiver Checking System OperationComplete Millivolt System Check LOG Placement Placing the Decorative RockFlame Appearance Checking the Pilot FlameMILLI-VOLT Control Checking the Burner Flame Operating InstructionsFor Your Safety Read Before Lighting Operating InstructionsWhat to do if YOU Smell GAS MILLI-VOLT Control Lighting Instructions To Turn OFF GAS to HeaterOperating Instructions and Cleaning and Servicing Cleaning and ServicingMatch Lighting Instructions Troubleshooting Observed Problem Possible Cause RemedyBurner does not light after ODS Illustrated Parts Breakdown Replacement Parts List Replacement Parts are Available Through Your RetailerLifetime Warranty Five Year WarrantyBasic Warranty