|
|
| THE MINELAB EXPLORER II |
CONNECTING THE SEARCH COIL |
| ||
The search coil transmits electromagnetic signals into the ground and receives | |||
the response. |
|
| |
|
|
| Rubber Washer |
Coil Cable |
|
| |
|
|
| Coil Yoke |
|
|
| Yoke Nut |
Yoke Bolt |
| Yoke Bracket | |
Search Coil |
|
| |
|
|
| |
Figure 2.1 | Connecting the search coil |
|
|
to the lower shaft | Connecting the search coil to the lower shaft | ||
|
| ||
|
| Figure |
|
|
| CAUTION | DO NOT attempt to disconnect the coil cable |
|
| where it enters the search coil itself. They are shipped | |
|
|
| |
|
| detector warranty. | |
|
| To attach the search coil to the lower shaft: | |
|
| STEP 1 Place the search coil on a flat surface close to the coil yoke. | |
|
| STEP 2 (Figure 2.2, following page) Plug the two black plastic | |
|
| washers into the recesses provided on either side of the coil | |
|
| yoke. |
|
|
|
| (Continued next page) |
|
|
| 19 |
|
|
| CONNECTING THE SEARCH COIL |