|
| THE MINELAB EXPLORER II |
|
| Fitting the armrest strap |
|
| Figure |
|
| To fit and adjust the armrest strap: |
|
| STEP 1 (Figure 2.11) Thread the strap through the buckle openings |
|
| as illustrated. |
|
| STEP 2 (Figure 2.12) Clip both buckles into the openings at each |
Figure 2.11 | Fitting buckle to armrest strap | outer side of the armrest. |
|
| STEP 3 Test by sliding your arm underneath the strap and resting |
|
| your forearm on the armrest (which should be adjusted to a |
|
| comfortable setting). |
|
| STEP 4 (Figure 2.13) Loosen strap by tilting the edge of the buckle |
|
| out to release it from the armrest. Undo the velcro and pull |
|
| the buckle outwards (towards yourself). Clip the buckle back |
|
| into place and tighten the strap by pulling up (in the direction |
|
| of the top arrow in Figure 2.13). |
|
| The armrest should now be adjusted to your satisfaction. Next time |
|
| you use your detector, all you will need to do is click the buckle back |
|
| into the armrest. |
Figure 2.12 | Fitting armrest strap to |
|
armrest |
|
|
Figure 2.13 | Tightening armrest strap |
|
|
| 25 |
|
| THE HANDLE ASSEMBLY |