Land Pride 357-187M manual Moving Mower with Stalled Engine, Moving the mower with a good battery

Land PrideTable of Contents

Section 2: Operating Procedures

Front of Mower Faces This Direction

23923

Figure 2-7

Moving Mower with Stalled Engine

Refer to Figure 2-8:

Each hydro-drive is equipped with a bypass valve for the purpose of moving the mower when the engine is inoperable.

Moving the mower with a good battery

1.Pull out on the bypass valve rods and lift them into the slot to lock in position. Both bypass valve rods are located at the rear of the engine platform.

2.Position both control levers in neutral with the handles together.

3.Turn ignition switch to on. Do not start the mower.

4.Manually move mower by hand or with a winch.

Moving the mower with a bad battery

1.Pull out on the bypass valve rods and lift them into the slot to lock them in position.

Refer to Figure 5-6 on page 34:

2.Remove hair pin cotter (#5), flat washer (#3) and clevis pin (#1) from actuator arm (#2). Be certain to do this to both the right and left transaxles. Push brake lever arms up to release park brakes.

3.The mower should move with moderate pressure once the park brakes have released.

4.Manually move mower by hand or with a winch.

IMPORTANT: Do not tow machine. Move it by hand or use a winch and load it on a trailer.

IMPORTANT: Following repairs, always make certain the two bypass valves are returned to their operating position and actuator pins are reinstalled.

Bypass Valve Rods

24895

Bypass Valve

Figure 2-8

1/12/09 Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor® 357-187M 15