Land Pride
Section 3: Adjustments
Table of Contents
Refer to Figure 3-13:
9.Start the leveling process on the left front side of the mower.
10.Set the amount of threads on the deck lift rod to protrude approximately 1” pass the lift block.
11.Jam both nuts against the lift block.
12.Push or pull on the deck lift foot pedal until the chain on the left front just becomes tight, making sure that the deck stays tight against the 3” block.
Lift | 1” Protrusion | Deck Lift | |
Assist | |||
Block |
| ||
| Spring | ||
|
| ||
| 1” |
|
Deck
Lift Rod
Nuts |
Left Front | 24897 |
Deck Lift Chain |
Deck Lift Rod Adjustment (Left Front Side Shown)
Figure
Refer to Figure 3-12:
13.While keeping the left front chain tight, tighten the nuts against the deck lift block on the height indicator rod.
Refer to Figure 3-11 on page 24:
14.Go to the right front of the mower.
15.Loosen the 5/16” jam nut for the 5/16" adjuster bolt and then back the adjuster bolt out to allow the adjuster to move up and down freely.
16.Be sure that the adjuster is free to move up and down. Tighten the adjuster bolt until the chain just becomes tight. Make sure the deck stays tight against the 3” block.
17.Tighten the adjuster bolt jam nut to prevent the adjuster bolt from moving.
18.Tighten the hardware holding the chain and adjuster onto the deck lift arm.
Refer to Figure 3-14:
19.Go to the right rear of the mower.
20.Make sure that there is still slack in the back right lift chain. If not, loosen the two nuts (“A” & “B”) on the lift block until there is slack in the right rear deck lift chain.
21.Tighten “B” nut until the chain just becomes tight, making sure that the deck stays tight against the 3” block.
23691
Threaded Rod
“A” Nut |
Lift Block |
“B” Nut |
Right Rear
Deck Lift Chain
Deck Lift Rod Adjustment (Right Back Side Shown)
Figure
Refer to Figure 3-15:
22.Go to the left rear of the mower.
23.Make sure that there is still slack in the chain. If not, loosen the two nuts (“A” & “B”) on the lift block until there is slack in the left rear deck lift chain.
24.Tighten “B” nut until the chain just becomes tight, making sure that the deck stays tight against the 3” block.
25.Tighten both RH and LH “B” nuts one more full turn to raise rear of the deck to be approximately 1/4" higher than the front.
26.Tighten “A” nut on both sides to jam it and “B” nut tightly against the lift block.
24897 | Lift |
| |
| Block |
Deck
Lift Rod
“A” Nut | “B” Nut |
Left Rear
Deck Lift Chain
Deck Lift Rod Adjustment (Left Rear Side Shown)
Figure
1/12/09 | Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers | 25 |