Nortel Networks BCM200, 400 4.0 Connecting the cables ASM wiring chart, Pin Wire color Port Set #

Chapter 9 Connecting the cables 147

Table 49 ASM wiring chart

Wiring for an ASM 8 or GASM8

25-pair female

amphenol	1T		2T	3T 4T	5T	6T	7T	8T
								33R
connector
	26R		28R 29R 30R31R 32R
		27R

WARNING: Ensure that you have Tip (T) and Ring (R) connected to the appropriate pins.

Pin	Wire color	Port	Set #
26	White-Blue	X01	1
1	Blue-White	X01	1
27	White-Orange	X02	2
2	Orange-White	X02	2
28	White-Green	X03	3
3	Green-White	X03	3
29	White-Brown	X04	4
4	Brown-White	X04	4
30	White-Slate	X05	5
5	Slate-White	X05	5
31	Red-Blue	X06	6
6	Blue-Red	X06	6
32	Red-Orange	X07	7
7	Orange-Red	X07	7
33	Red-Green	X08	8
8	Green-Red	X08	8
34-50	no connection
9-25

Note: Refer to “Assigning line and extension numbers” on page 121 to see the relationship between the DS30 channel number and the DNs. Configuration information is included in the BCM 4.0 Administration Guide.

2Install the telephones and peripheral equipment (if it is a new system): a Attach the cables for the telephones to the connecting blocks.

b Install the telephones. Refer to “Installing telephones and peripherals” on page 161.

3Plug the female amphenol connector into the interface on the front of the MBM.

4Set up any mobile system you are using.

•Ensure the base stations are correctly installed and connected to the appropriate MBMs on the BCM system. In the case of the Wireless LAN IP telephone system, ensure that the access point is correctly set up to connect to the BCM system LAN or WAN.

•Configure and register the handsets according to the instructions provided for each type of system.

BCM200/400 4.0 Installation and Maintenance Guide