Nortel Networks BCM200, 400 4.0 manual Startup Profile times and LED sequence

Chapter 17 Using the Startup Profile to configure parameters 209

Note: Make sure the bootup sequence is complete before removing the USB storage device from the BCM system.

The Startup Profile is now loaded on your BCM system.

Startup Profile times and LED sequence

Table 76 provides details about the BCM system boot times and LED sequence using the Startup Profile to configure system parameters.

Table 76 Startup Profile times and LED sequence

	Cummulative
Duration	time
(minutes)	(minutes)	Power LED	Status LED	Comments
2	2	Solid green	Flashing green
4	6	Solid red	off
2	8	Solid green	Solid green	Initial boot sequence complete
30	38	Solid red	Solid green	Startup Profile functioning. Duration
				varies depending on selected
				parameters.
2	40	Solid green	Flashing green	Startup Profile is successfully applied.
			Off (error)	If there is an error the remaining steps
				are not completed.
4	44	Solid red	off	Duration varies based on selected
				parameters.
2	46	Solid green	Solid green	Reboot complete and system is
				functional.
				Note: You can safely remove USB
				device.

Note 1: If you use Element Manager to configure the parameters, the overall times are similar. Startup Profile enables you to configure multiple parameters at once, rather than individually using Element Manager.

Note 2: To re-apply the Startup Profile, remove the applied keycode file by returning the system to factory defaults using the BIT tool.

Next step

After you have loaded the Startup Profile, you can complete the installation process. Refer to “Completing the initial installation (optional)” on page 211 for more information.

BCM200/400 4.0 Installation and Maintenance Guide