Nortel Networks 400 4.0, BCM200 manual Setting MBM DIP switches, To set MBM DIP switches

120Chapter 8 Installing a media bay module (MBM)

Setting MBM DIP switches

Before you install the MBMs into the BCM system, you must set the DIP switches. Make a note of these settings either on the chart shown in Table 28 or in the Programming Record form.

To set MBM DIP switches

1Locate the DIP switches on the MBM. See Figure 70.

Figure 70 MBM DIP switches

Underside of the
MBM
6	5 4	3	2	1	Off
					On
						MBM is
DIP switches				On	1 2 3 4 5 6	right-side up
Back of the MBM
				Off
Rear view of the MBM

Note: The GASM and GATM MBMs have a different DIP switch configuration than shown in Figure 70.

2Set the switches to correspond with the settings you chose in the procedure “To determine MBM DIP switch settings” on page 116.

3Repeat step 2 for each MBM you want to install.

N0060612