Nortel Networks manual Installing a primary hard disk into a RAID hard disk cage, BCM200 shown

Chapter 22 Replacing the hard disk 269

Warning: Protect the hardware components against damage from electrostatic discharge. Always wear a grounded wriststrap before you handle components. Always place the components in a static-free container.

To install a hard disk into a standard configuration hard disk cage

1Position the hard disk into the bottom position of the hard disk cage.

Note: For a BCM200 system, orient the hard disk so that the power and IDE connectors are on the bottom and opposite to the hard disk cage lift tab (see Figure 130).

For a BCM400 system, orient the hard disk so that the power and IDE connectors are on the bottom and on the same side as the hard disk cage lift tab.

2Align the hard disk and hard disk cage retaining screw holes. Fasten the hard disk cage retainer screws into both sides of the hard disk cage (see Figure 130).

Figure 130 Install a single hard disk in the standard configuration hard disk cage

1	Insert the hard disk into the	BCM200 shown	Rear view
	hard disk cage

Front view

IDE connector

Power supply connector

Hard disk		Align and install the
	2	hard disk retainer
cage lift
		screws
tab

Note: Install the BCM200 hard disk so that the IDE and power connectors are opposite to the hard disk cage lift tab

Installing a primary hard disk into a RAID hard disk cage

Use this procedure to install a primary hard disk into the RAID hard disk cage for the BCM200 or BCM400 system. Use this procedure if you need to replace a faulty primary hard disk or install a programmed hard disk from a standard configuration.

BCM200/400 4.0 Installation and Maintenance Guide