Cisco Systems 1700 manual Installing WAN Interface Cards, Safety Information

Chapter 2 Installing the Cisco 1700 Router

Installing WAN Interface Cards

The Cisco 1700 router supports one or two Cisco WAN interface cards. Each card has one or two WAN ports. This section describes the general procedure for installing a card in the Cisco 1700 router.

Note For details on specific WAN interface cards, how to connect the card to the WAN line, and how to configure the interface with Cisco IOS software, refer to the Cisco WAN Interface Cards Hardware Installation Guide that came with the card(s).

Safety Information

This section lists safety warnings that you should be aware of before installing WAN interface cards in the router.

Warning Only trained and qualified personnel should be allowed to install or replace this equipment. (To see translated versions of this warning, refer to the Regulatory Compliance and Safety Information for the Cisco 1700 document that came with the router.)

Warning Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals. (To see translated versions of this warning, refer to the Regulatory Compliance and Safety Information for the Cisco 1700 document that came with the router.)

Warning Before opening the chassis, disconnect the telephone-network cables (from the card) to avoid contact with the telephone-network voltages. (To see translated versions of this warning, refer to the Regulatory Compliance and Safety Information for the Cisco 1700 document that came with the router.)

	Cisco 1700 Router Hardware Installation Guide
2-4	78-5405-03