Cisco Systems 1700 manual Connecting Power to the Router

Chapter 2 Installing the Cisco 1700 Router

Connecting Power to the Router

Read the following warnings before connecting the router to power.

Warning The power supply is designed to work with TN power systems.

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker no larger than 120VAC, 15AU.S. (240VAC, 16A international) is used on the phase conductors (all current-carrying conductors).

Warning This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.

Take the following steps to connect power to the router and to turn the router on:

Step 1 Connect the attached power-supply cord to the power socket (labeled +5,+12,-12 VDC) on the router rear panel.

Step 2 Connect one end of the separate power cord to the socket on the power supply.

Step 3 Connect the other end of the separate power cord to a power outlet.

Step 4 Press the router power switch to ON ( ).

Step 5 Confirm that the router has power by checking that the

PWR LED on the front panel is on.

	Cisco 1700 Router Hardware Installation Guide
2-8	78-5405-03