Nortel Networks 400 4.0, BCM200 manual Removing an MBM, To remove an MBM

250Chapter 21 Replacing a media bay module

Removing an MBM

Use the procedures is this section to remove one or more MBMs from a BCM main unit or expansion unit.

To remove an MBM

1Power down the BCM system (see “Performing a system shutdown” on page 231).

2Remove any cabling from the MBM faceplate.

3Grasp the right edge of the MBM ejector lever with your thumb, index and middle fingers. Pull outward to partially eject the MBM. Pull further on the lever to eject the MBM from the bay. Refer to Figure 119, Figure 120, or Figure 121.

4Grasp the top and bottom edges of the MBM. Remove the MBM from the BCM unit (see Figure 119, Figure 120, and Figure 121). Place the MBM in a clean, safe, and static-free area.

Figure 119 Remove a BCM200 MBM

Grasp the edge of the MBM ejector lever and pull outward

N0060612