Nortel Networks BCM200, 400 4.0 manual To configure Dhcp server settings, Date and Time attributes

Chapter 16 Using Element Manager to set the basic parameters 199

3Configure the Date and Time attributes (see Table 69).

Table 69 Date and Time attributes

Attribute	Description
Date and Time source	Set to NTP if the system uses a network server to determine the correct
	time and date.
	Set to Trunk if you want to receive time and date settings from PSTN (if
	available).
	Set to Manual if you want to be able to manually configure the time and
	date for your system.
NTP server	If Date and Time source is set to NTP, then enter an address for the
	server.
Date and time	Use the drop-down calendar to select the correct date and time.
Time zone	Select the time zone for this system.

To configure DHCP server settings

1From the Configuration tab, click the Data Services folder to expand it.

2Select DHCP Server.

3Select the DHCP Settings tab.

4Configure the DHCP mode attribute. Select either DHCP Server or DHCP Relay Agent from the dropdown list.

5Click the Subnets tab and select the LAN1 heading. The details panel for LAN1 appears.

6Select the General Settings tab.

7Configure the attributes according to the following table.

Table 70 Subnets: General Settings attributes (Sheet 1 of 2)

Attribute	Description
IP domain name	The domain name of the network.
Primary DNS IP address	Allows you to specify the IP addresses of the primary DNS server in a valid dot
	format.
	BCM automatically assigns the value for this parameter. If the IP address or
	subnet mask for the corresponding LAN interface changes, this value is
	overwritten. Use caution when changing this value.
Secondary DNS IP address	Allows you to specify the IP addresses of the secondary DNS server in a valid
	dot format.
	BCM automatically assigns the value for this parameter. If the IP address or
	subnet mask for the corresponding LAN interface changes, this value is
	overwritten. Use caution when changing this value.
WINS server address	Allows you to specify the IP address of the WINS server.
	BCM automatically assigns the value for this parameter. If the IP address or
	subnet mask for the corresponding LAN interface changes, this value is
	overwritten. Use caution when changing this value.

BCM200/400 4.0 Installation and Maintenance Guide